Polycom IP 500 manual Safety and Compliance, Display shows Network Link is Down, Modifications

Page 21

Display shows “Network Link is Down”

To check LAN status, press the Menu key followed by System Sta- tus and Network Statistics. Scroll down to see if LAN port shows Active or Inactive.

Check the termination at the switch or hub end of the network LAN cable. Ensure that the switch/hub

port connected to the telephone is operational (if accessible - other- wise contact your System Adminis- trator).

Reboot the telephone to attempt reconnection to the network.

Safety and Compliance

Part 15 Rules

This device is compliant with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1.This device may not cause harmful interference, and

2.This device must accept any inter- ferences received, including inter- ference that may cause undesired operation.

Class B Digital Device or Peripheral

Note: This equipment is tested and com- plies with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to pro- vide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interfer- ence to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can

be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

1.Reorient or relocate the receiving antenna.

2.Increase the separation between the equipment and receiver.

3.Connect the equipment into an out- let on a circuit different from that to which the receiver is connected.

4.Consult the dealer or an experi- enced radio/TV technician for help.

Modifications

In accordance with Part 15 of the FCC Rules, the user is cautioned that any changes or modifications not expressly

approved by Polycom, Inc. could void the user’s authority to operate the equipment.

Installation Instructions

Installation must be performed in accor- dance with all relevant national wiring rules.

L’Installation doit être exécutée confor- mément à tous les règlements nationaux applicable au filage électrique.

18

Image 21
Contents Menu DelContents Part 15 Rules Introduction Parts ListConnecting Network and Power Source Installing SoundPoint IP 500 SIPAC Power Option In-Line Power OptionAttaching the Base Connecting the Handset and Optional HeadsetFeatures Key Description Key DescriptionsUsing the Handset Using SoundPoint IP 500 SIPUsing Handsfree Speakerphone Mode Using the HeadsetAnswering a Call Call HoldMicrophone Mute Local Conferencing Call TimerTransferring a Call Ending a CallCall Forwarding Volume AdjustmentVoice Mail Do Not DisturbDisplay Contrast Headset Auto ModeRing Type See also Distinctive Ringing / Call TreatmentLocal Directory Call ListsEdit Speed DialMultiple Lines Multiple Call AppearancesEndCall Select Message Center*,† Voice and Text MessagingPresence / Status / Buddy Lists Distinctive Ringing / Call TreatmentPhone Reboot Instant MessagingMultilingual Support Localization Troubleshooting Installation Instructions Safety and ComplianceDisplay shows Network Link is Down Class B Digital Device or PeripheralPlug Acts as Disconnect Device Polycom Limited Warranty and Limitation LiabilityIndustry Canada IC CE and Vcci MarkService Agreements Warranty ExclusiveExclusions Limitations of LiabilityDisclaimer Governing LawCopyright Notice For information, visit Polycom, Inc Barber Lane Milpitas, CA
Related manuals
Manual 13 pages 62.42 Kb