If the talk/batt low LED begins to flash, the phone is programmed to limit its functions to save power. The table below describes what to do to return your phone to normal operation.
DURING A CALL | IN STANDBY MODE | 1 | |
|
|
|
|
Only the talk button operates. | None of the buttons will operate. |
|
|
|
|
|
|
The Handset beeps and the | The Handset talk/batt low LED |
|
|
talk/batt low LED flashes once | flashes once every 3 seconds. |
|
|
everv 3 seconds. |
|
|
|
Complete your call as quickly as | You will not be able to make a call. |
|
|
possible. |
|
|
|
Return the Handset to the Base | Return the Handset to the Base |
|
|
Unit for charaina. | Unit for charaina. |
| I |
|
|
|
|
Note: Allow 15 to 20 hours without any interruption for the Handset to fully recharge.
Setting the Pulse/Tone Switch*
Be sure the PULSE/TONE switch is in the TONE position.
Note: Most phone systems are Tone dialing. Check with your local phone company if you are not sure whether your system is Tone or Pulse dialing.
*The New Zealand model is a tone only telephone and the Pulse/ Tone switch has been disabled.
25
Adjusting Ringer/Volume Controls
Handset Ringer Control
You can also select the ringer tone or ringer volume for the Handset.
Press ringer to select a different ringer tone or ringer volume when the phone is not in use.
1 | 4 |
Handset Ringer Tone Select
Button
Base Volume Controls
To adjust the Base Unit ringer volume, move the RING
26