Uniden XCA750 manual Chain Dialing, Erasing a Stored Number

Page 22

4.Press the memory location number (0-9).

3.Press the memory location number (0-9).

A tone indicates the number is erased.

Chain Dialing

On certain occasions, after dialing a number, you may be requested by the party or service you are calling to enter a special access code, such as when performing a banking transaction. To do this, simply:

1.Store the access code into one of the memory numbers.

2.Dial the main number.

3.At the appropriate time, press @ followed by the memory location number where the access code is saved.

Erasing a Stored Number

To erase a number previously stored in a memory location (0-9), follow these steps:

1.Remove the Handset from the Base Unit.

2.Press @ twice.

Note: An error tone will sound and the erase procedure will be canceled if more than 20 seconds elapse between each keystroke entry or step.

37

38

Image 22

Contents Page Precautions Answering Device Remote KeysPage Contents Important Safety Instructions Battery Safety PrecautionsIntroduction Included with the XCA65O!!CA750Range Telephone Line ProblemsImportant Electrical Considerations Radio lntetferenceApplying Power to the Base Unit InstallationConnecting the Telephone Cords Selecting a LocationDesk or Tabletop Installation Direct Wall Mounting Page Setting the Handset Retainer Installing the Handset Battery Pack Setting Up Your PhoneExtending the Antenna Cleaning the Battery Contacts Charging the Battery PackLow Battery Indicator Continuous Battery ChargingCharging from the Charging Cradle Adjusting Ringer/Volume Controls Handset Ringer Control Setting the Pulse/Tone SwitchBase Volume Controls Automatic Digital Code Security Using Your Phone Making and Receiving CallsChanging Channels, Flash, and Page/Find Programming Your PhoneStoring a Number in Memory Storing a Mixed Number Australian Model Only Dialing a Stored Number Chain Dialing Erasing a Stored NumberIntegrated Answering System Answering System SetupFeatures Turning the Answering System On/Off HandsetOperationSetting the Clock BaseOperationReviewing Time and Day Stamp HandsetOperation Press a to hear the current Time and Day StampPreset Messages Recording Your Personal OGM HandsetOperationBase Operation Selecting a Preset OGM Preset message will begin to play on the Base Unit speakerUsing the Reset Button Using Your Answering SystemPlaying New Messages HandsetOperation Playing a Stored Message HandsetOperation Repeating a Message HandsetOperation Talik/batt low LED goes Skipping a Message HandsetOperation Press bb until you get to the message you want to playDeleting a Message HandsetOperation Message Counter LED shows the total number of messagesDeletingAllMessages Message Full Indication Voice-Guided Help MenuScreening Incoming Calls Leaving a Memo MessageRemote Operation Setting Your PIN CodeRecording a Telephone Conversation Using a Touch-Tone Phone Troubleshooting Telephone Troubleshooting ChartSpecifications Answering System Troubleshooting ChartMiderr