Uniden XCA750 manual Programming Your Phone, Changing Channels, Flash, and Page/Find

Changing Channels, Flash, and Page/Find

To change channels or access call waiting while the phone is in use, or to use the one-way page to locate the Handset, follow these steps:

	I	HANDSET	I	BASE UNIT
		Press @		Note: You must use the
CHANGING		Note: Change channels to		Handset to change
CHANNELS		help eliminate background		channels.
		noise.
		If the call waiting tone
		sounds, press @to accept
		the waiting call.
				Note: The Base Unit does
FLASH		-OR-		not have 8. You must use
				the Handset for call waiting
				and to make a call.
		If you have finished a call
		and want to make another
		call, press @I to hang up
		and aet a dial tone.
		Note: When page/find is		Press page/find on the
PAGE/FIND		pressed on the Base Unit,		Base Unit to locate the
		the Handset beeps.		Handset.

Note: If you do not have any special phone service, pressing FLASH might disconnect the current call.

If the above FLASH operation does not work and you have the “Easy Call” service connected then follow your service provider’s instruction to operate “Call waiting’:

Programming Your Phone

For convenience, the Handset has ten memory locations so you can store the numbers you use most often in either place. Just remember that all programming functions must be completed when your phone is in the standby mode, since the programming keys do not function while you are on the phone.

Storing a Number in Memory

Use these keys to store a number in memory with the Handset.

Note: An error tone will sound and the programming procedure will be canceled if more than 20 seconds elapse between each keystroke entry or step.

1.Remove the Handset from the Base Unit.

2.Press @ .

The talk/batt low LED blinks.

31 32