Uniden XCA750 manual Automatic Digital Code Security

Page 17

To adjust the Base speaker volume, press the volume control switch to achieve the desired setting.

Automatic Digital Code Security

To avoid unauthorised calls on your phone, a Digital Code feature was added to all XCA650/XCA750 phones. This Digital Code is shared only between the Handset and Base Unit. The code is set automatically when you first use the phone.

To change the Digital Code, be sure the Handset is on the Base, then:

1. Press page/find on the Base Unit. -

2.After the Handset stops beeping, remove it from the Base Unit.

3.Wait 5 seconds then place the Handset on the Base Unit.

The charge LED will blink quickly, indicating that the code has changed.

27

28

Image 17
Contents Page Answering Device Remote Keys PrecautionsPage Contents Battery Safety Precautions Important Safety InstructionsIncluded with the XCA65O!!CA750 IntroductionImportant Electrical Considerations Telephone Line ProblemsRange Radio lntetferenceConnecting the Telephone Cords InstallationApplying Power to the Base Unit Selecting a LocationDesk or Tabletop Installation Direct Wall Mounting Page Setting the Handset Retainer Extending the Antenna Setting Up Your PhoneInstalling the Handset Battery Pack Charging the Battery Pack Cleaning the Battery ContactsCharging from the Charging Cradle Continuous Battery ChargingLow Battery Indicator Base Volume Controls Setting the Pulse/Tone SwitchAdjusting Ringer/Volume Controls Handset Ringer Control Automatic Digital Code Security Making and Receiving Calls Using Your PhoneStoring a Number in Memory Programming Your PhoneChanging Channels, Flash, and Page/Find Storing a Mixed Number Australian Model Only Dialing a Stored Number Erasing a Stored Number Chain DialingFeatures Answering System SetupIntegrated Answering System Turning the Answering System On/Off HandsetOperationBaseOperation Setting the ClockPress a to hear the current Time and Day Stamp Reviewing Time and Day Stamp HandsetOperationRecording Your Personal OGM HandsetOperation Preset MessagesBase Operation Preset message will begin to play on the Base Unit speaker Selecting a Preset OGMPlaying New Messages HandsetOperation Using Your Answering SystemUsing the Reset Button Playing a Stored Message HandsetOperation Repeating a Message HandsetOperation Talik/batt low LED goes Press bb until you get to the message you want to play Skipping a Message HandsetOperationMessage Counter LED shows the total number of messages Deleting a Message HandsetOperationDeletingAllMessages Voice-Guided Help Menu Message Full IndicationLeaving a Memo Message Screening Incoming CallsRecording a Telephone Conversation Setting Your PIN CodeRemote Operation Using a Touch-Tone Phone Telephone Troubleshooting Chart TroubleshootingAnswering System Troubleshooting Chart SpecificationsMiderr