Philips M888 manual Get started, Connect the base station, Install the handset

3 Get started

Caution

•• Make sure that you have read the safety instructions in the 'Important safety instructions' section before you connect and install your handset.

Connect the base station

Warning

•• Risk of product damage! Ensure that the power supply voltage corresponds to the voltage printed on the back or the underside of the phone.

•• Use only the supplied power adapter to charge the batteries.

Note

•• If you subscribe to the digital subscriber line (DSL) high speed internet service through your telephone line, ensure you install a DSL filter between the telephone line cord and the power socket.The filter prevents noise and caller ID problems caused by the DSL interference. For more information on the DSL filters, contact your DSL service provider.

•• The type plate is located on the bottom of the base station.

1 Connect each end of the power adapter to:

• the DC input jack at the bottom of the base station;

• the power socket on the wall.

2 Connect each end of the line cord to:

•the telephone socket at the bottom of the base station;

•the telephone socket on the wall.

8EN

Install the handset

The batteries are pre-installed in the handset. Pull the battery tape off from the battery door before charging.

Caution

•• Risk of explosion! Keep batteries away from heat, sunshine or fire. Never discard batteries in fire.

•• Use only the supplied batteries.

•• Risk of decreased battery life! Never mix different brands or types of batteries.

Note

•• Charge the batteries for 8 hours before first use.

•• If the handset becomes warm when the batteries are being charged, it is normal.