3 Select [Remote access] > [Change PIN], then press [OK] to confirm.
4 Enter the old PIN/passcode, then press [OK] to confirm.
5 Enter the new PIN/passcode, then press [OK] to confirm.
6 Enter the new PIN/passcode again, then press [Save] to confirm.
»»The setting is saved.
Charge the handset
Charge your handset by docking it in either direction.When the handset is placed correctly on the base station, you hear a docking tone (see 'Set the docking tone' on page 31).The LED at the back of the handset flashes once.
»»The handset starts charging.
Note
•• Charge the batteries for 8 hours before first use.
•• If the handset becomes warm when the batteries are being charged, it is normal.
•• Over time, capacity of batteries decreases.This is a normal battery behavior.
Your phone is now ready to use.
Check the battery level
The battery icon displays the current battery level.
When the handset is off the base station/charger, the bars indicate the battery level (from full to low). When the handset is on the base station/charger, the bars flash until charging is complete.
The empty battery icon flashes. The battery is low and needs recharging.
If you are on the phone, you hear warning tones when the batteries are almost empty. The handset turns off when the batteries are completely empty.
What is standby mode?
Your phone is in standby mode when it is idle. When the handset is off the charging cradle, the standby screen displays the date and time. When the handset is on the charging cradle, the standby screen displays the time as a screen saver.
Check the signal strength
The number of bars indicates the connection status between the handset and base station.The more bars are shown, the better the connection is.
•Make sure the handset is linked to the base station before you make or receive calls and carry out the functions and features.
•If you hear warning tones when you are on the phone, the handset is almost out of battery or the handset is out of range.
10EN