ClearSounds A300E manual Desk / Table Mounting

Bottom of base

Desk / Table Mounting

1.Plug the AC power adapter into the jack on the bottom of the base, then plug the AC adapter into a standard electrical outlet or surge protector.

NOTE: The adapter is required for the phone to work.

Installing Batteries Three AAA re-chargeable Ni-MH batteries come with your phone. You must install the batteries before using your phone.

1.Remove the battery compartment cover by sliding it downwards.

2.Insert the new batteries. Be sure to observe battery polarity as imprinted on the inside of the compartment.

3.Replace the battery compartment cover by sliding upward until it clicks into place.

NOTE: The batteries need to be replaced if they do not recover their full storage capacity after recharging. Check the battery icon on the LCD to see the battery charge level. When replacing the batteries, always use good quality Ni-MH AAA re-chargeable batteries.

Charging the Handset

1.Place the handset into the base. The LCD screen will light up and you will hear a beep to indicate charging has begun.

2.Important: Before initial operation, you should fully charge the handset for at least 15 hours.

3.After the batteries are fully charged, begin the registration process as described on page 8.

6 – ENGLISH