Answering System
Remote Operation from a Touch Tone Phone
You can operate the answering system from any touch tone phone.
Firstly you must store your remote code using the handset near the base unit. The
Setting the Remote Code ON
1 | Press JOYSTICK | 2 | Select “ | TAM | 3 | Select “Setting |
| (or move). |
| Operation”. |
| TAM”. | |
4 | Select “Remote | 5 | Enter | 6 | Press JOYSTICK. | |
| Code”. |
| Code. |
|
|
|
Setting the Remote Code OFF
Follow steps 1 to 4 shown above, then:
5 Press x. | 6 Press JOYSTICK. | ||
|
|
|
|
•The factory preset is Remote Code OFF.
Turning ON the Answering System Remotely
You can turn on the answering system from any touch tone phone.
|
|
|
|
1 | Call from a touch tone phone | 2 | Enter Remote Code within 10 seconds after a |
| then wait for 15 rings. |
| long beep. |
| 4 | Voice menu starts after 3 seconds. | |
3 after the greeting message | Follow the guidance (see page 70). |
playback.
OR
Enter your desired direct remote command (see next page).
•If your remote code is not stored, you cannot turn on the answering system remotely.
68