Panasonic KX-TCD430AL operating instructions Technical information

Page 30

TCD430AL(E).book Page 30 Tuesday, March 30, 2004 5:27 PM

Useful Information

redialled. Redial the number manually.

The handset beeps intermittently and/or 074 flashes.

LFully charge the batteries (page 8).

I fully charged the batteries, but 074 still flashes.

LClean the charge contacts and charge again (page 8).

LIt is time to replace the batteries (page 9).

7disappears and the unit stops charging when the handset is on the base unit.

LNickel cadmium batteries are inserted when the battery type is set to “NI-MH”. Change the battery type setting to “NI- CD” (page 21).

Caller information is not displayed.

LYou must subscribe to Caller ID service.

While viewing caller information, the display returns to standby mode.

LDo not pause for over 60 seconds while searching.

I cannot register a handset to a base unit.

LThe maximum number of base units (4) are already registered to the handset. Cancel unused base unit registrations from the handset (page 26).

LThe maximum number of handsets (6) are already registered to the base unit. Cancel unused handset registrations from the base unit (page 26).

LYou entered the wrong PIN number. If you forget your PIN, consult your nearest Panasonic service centre.

LLocate the handset and the base unit away from other electrical appliances.

Technical information

Standard: DECT (Digital Enhanced

Cordless Telecommunications),

GAP (Generic Access Profile)

Number of channels: 120 Duplex Channels

Frequency range: 1.88 GHz to 1.9 GHz

Duplex procedure: TDMA (Time Division Multiple Access)

Channel spacing: 1728 kHz

Bit rate: 1152 kbit/s

Modulation: GFSK (Gaussian Frequency Shift Keying)

RF Transmission Power: Approx. 250 mW

Voice coding: ADPCM 32 kbit/s

Power source: AC adaptor 220–240 V, 50 Hz

Power consumption, Base unit: Standby:

Approx. 3.5 W, Maximum: Approx. 9.2 W

Operating conditions: 5 °C–40 °C, 20 %– 80 % relative air humidity (dry)

Dimensions, Base unit: Approx. 58 mm x 128 mm x 105 mm

Dimensions, Handset: Approx. 143 mm x 48 mm x 32 mm

Mass (weight), Base unit: Approx. 170 g

Mass (weight), Handset: Approx. 120 g

Note:

LSpecifications are subject to change.

LThe illustrations used in these operating instructions may differ slightly from the actual product.

30

Page 29 Page 31
Image 30
Page 29 Page 31
Contents Model No. KX-TCD430AL Telephone Additional/replacement accessories Accessory informationIncluded accessories Model No DescriptionGeneral Battery cautionImportant information EnvironmentInstructions to customer Installation Service difficulties Base unit Location of controlsHandset Receiver Display Phonebook Talk NavigatorBattery strength Battery installationBattery charge ConnectionsBattery replacement Turning the power on/offWall mounting Redial feature Other featuresMaking calls Answering calls Handset locatorKeys Editing a stored entryErasing a stored entry To edit/correct a mistakeHot key quick dial Making calls using the phonebookMaking calls using a hot key Assigning an entry in the phonebook to a hot keyCall waiting and Caller ID compatible Caller ID serviceUsing Caller ID type Viewing caller information and calling backStoring caller information into the phonebook Editing a caller’s phone number before calling backErasing caller information ExampleGuide to handset settings 2nd menu 3rd menu Default settingHandset settings Time alarmRinger options Display options Selecting the standby mode displaySelecting the talk mode display Tone optionsSelecting the display language Setting call barCall options Storing the direct call numberOther options Adjusting ringer volume Guide to base unit settingsBase unit settings Setting recall timeCancelling a restricted number Setting pause lengthSetting call restriction Turning on/off call restrictionResetting the base unit to its default settings Additional handsets Operating additional unitsRegistering a handset to a base unit Additional base unitsCancelling a base unit Cancelling a handsetSelecting a base unit Setting all handsets to ring Setting the selected handsets to ringHandset To transfer a call directly without speaking to handsetTroubleshooting Technical information Index PINSales Department Panasonic Australia Pty. Limited For your future referenceCustomer Support Centre Tel. No Manufacturer
Top Page Image Contents