Panasonic KX-TG7531, KX-TG7534, KX-TG7533, KX-TG7532 operating instructions Error messages

Page 42

Useful Information

Error messages

If the unit detects a problem, one of the following messages is shown on the display.

Display message	Cause/solution
Base no power	L The handset has lost communication with the
	base unit. Move closer to the base unit and try
or	again.
No link to base.	L Unplug the base unit’s AC adaptor to reset the
No link to base.	unit. Reconnect the adaptor and try again.
Reconnect main base AC	L The handset’s registration may have been
adaptor.	canceled. Re-register the handset (page 28).
Busy	L The called unit is in use.
	L Other units are in use and the system is busy.
	Try again later.
	L The handset you are using is too far from the
	base unit. Move closer and try again.
Call phone company for	L You have not stored the voice mail access
your access #	number. Store the number (page 39).
Check tel line	L The supplied telephone line cord has not been
	connected yet or not connected properly.
	Check the connections (page 9).
Error!!	L Recording was too short. Try again.
Invalid	L There is no handset registered to the base
	unit matching the handset number you
	entered.
	L The handset is not registered to the base unit.
	Register the handset (page 28).
Requires subscription	L You must subscribe to a Caller ID service.
to Caller ID.	Once you receive caller information after
	subscribing to a Caller ID service, this
	message will not be displayed.
Use rechargeable	L A wrong type of battery such as Alkaline or
battery.	Manganese was inserted. Use only the
	rechargeable Ni-MH batteries noted on page
	4, 7.

42For assistance, please visit http://www.panasonic.com/help

Image 42

Contents Before initial use, see Getting Started on Introduction Caller ID ServiceVoice Mail Service Important InformationAccessory information Supplied accessoriesModel composition Optional handset feature overview Additional/replacement accessoriesAccessory item Order number FeatureRange extender Range extender KX-TGA405For your safety Important safety instructions Other information Battery charge Setting upBattery installation ConnectionsDuring a power failure Battery level IconOperation Operating time Intelligent eco mode ControlsHandset Display Base unitDisplay language Initial settingsDialing mode Voice guidance languageBelt clip Using soft key Temporarily switching the display modeProgramming the display mode beforehand Wall mounting Charger onlyMaking calls Answering callsMute Useful features during a callHold FlashTemporary tone dialing for Rotary/pulse service usersWay conference Privacy mode Handset clarity boosterShared phonebook Adding entriesGroups Erasing entries Finding and calling a phonebook entryEditing entries Group nameChain dial Menu Programmable settingsProgramming by scrolling through the display menus Main menu Sub-menuProgramming using the direct commands Access# Tone 0Melody Silent modeCaller ID auto Adjustment*6 Manual Handset name 1100 PM/0600 AMSet flash Set dial modeMode*10 Privacy mode 900 ms Time*9On Off Answer on Min Greeting only Remote code111 Screen call Answer offSilent mode AlarmSpecial programming Changing the handset name Call block Caller ID subscribers onlyRegistering a unit Operating additional unitsRegistering a handset to the base unit Talking Caller ID Using Caller ID serviceCaller ID features Missed callsViewing the caller list and calling back Caller listGroup ringer tone for phonebook Editing a caller’s phone number before calling backErasing all caller information Caller ID number auto edit featureErasing selected caller information Storing caller information to the phonebookMemory capacity including your greeting message Answering systemTurning the answering system on/off Call screeningListening to messages using the base unit Greeting messageListening to messages from the message list Listening to messages using the handsetSettings menu Operating the answering systemRemote operation Remote access codeUsing the answering system remotely Calling back Caller ID subscribers onlyWhen the Spanish voice guidance is selected Remote commandsWhen the English voice guidance is selected Voice guidanceNumber of rings before the unit answers a call Answering system settingsFor voice mail service subscribers Caller’s recording timeMessage alert To erase the voice mail access number Voice mail service Storing the voice mail VM access number Voice mail VM tone detectionListening to voice mail messages Making an intercom call IntercomHandset locator Answering an intercom callError messages Troubleshooting General use Problem Cause/solutionProgrammable settings Problem Cause/solution Battery recharge Problem Cause/solution Problem Cause/solutionMaking/answering calls, intercom Caller ID/Talking Caller ID Problem Cause/solution Answering system Problem Cause/solution Liquid damage Problem Cause/solution FCC and other information FCC RF Exposure Warning Guía Rápida Española Correcto IncorrectoSugerencias de operación Fecha y hora Auricular Preguntas frecuentes Customer services Or, contact us via the web atTTY users hearing or speech impaired users can call One Panasonic Way, Secaucus, New Jersey Warranty For United States and Puerto RicoShip-In Service Parts Labor One 1 YearLimited Warranty Limits And Exclusions Index Page Page For your future reference Copyright