Panasonic KX-TG4311BX, KX-TG4312BX Registration Problem Cause/solution, Handset Menu i#130

Page 38

TG4311BX.book Page 38 Monday, November 10, 2008 9:32 AM

Useful Information

Registration

Problem

Cause/solution

The handset registration may

L Re-register the handset.

have been canceled or the

1 Handset: {MENU} i{#}{1}{3}{0}

communication between the

2 Base unit: Press and hold {LOCATOR}

base unit and the handset is

for 4 seconds. (No registration tone).

unstable.

– If another registered handset start

 

 

ringing, press the same button to stop.

 

Then repeat this step. (KX-TG4312)

 

– The next step should be completed

 

within 90 seconds.

 

3 Handset: Press {OK}, then wait until a

 

beep sounds. i{OFF}

 

– While registering, “Base registering”

 

is displayed on another handset.

 

(KX-TG4312)

 

If the registration fails, try to deregister the

 

handset.

 

KX-TG4311

 

Press {MENU} i{#}{1}{3}{1} i

 

{3}{3}{5} i{OK} i{1}, then re-register

 

it again.

 

KX-TG4312

 

Use another handset to deregister the

 

unstable handset. Press {MENU} i

 

{#}{1}{3}{1} i{3}{3}{5} i{OK} i

 

{1} or {2} (The handset number which you

 

want to cancel). Try to re-register it again.

 

L If the above remedy does not solve the

 

problem, contact your nearest Panasonic

 

service center.

38

Page 37 Page 39
Image 38
Page 37 Page 39
Contents Operating Instructions Introduction Caller ID ServiceVoice Mail Service PreparationThank you for purchasing a Panasonic digital cordless phone Product informationNotable differences between the models KX-TG4311 seriesReplacement battery information Accessory informationSupplied accessories Quantity KX-TG4311 KX-TG4312For your safety For best performance Important safety instructionsBattery Base unit location/avoiding noiseEnvironment Routine careCharge contacts ControlsBase unit Handset SpeakerBase unit DisplayConnections If you subscribe to a DSL/ADSL service Battery installation and replacementDuring a power failure ChargerBattery charge Battery level Battery iconSymbols used in these operating instructions Date and time Setting up the unit before useDialing mode Save iOFFMaking calls Answering callsHold Useful features during a callAdjusting the handset ringer volume MuteHandset clarity booster Temporary tone dialing for rotary/pulse service usersDial lock Call shareFinding and calling a phonebook entry PhonebookAdding entries Chain dial Editing entriesErasing entries NextMenu Programmable settingsProgramming by scrolling through the display menus Main menu Sub-menuTG4311BX.book Page 20 Monday, November 10, 2008 932 AM Programming using the direct commands Feature Setting code System CodeFeature Setting code System Code Setting*1 Caller IDauto Adjustment*7Alarm Special instructions for programmable settingsNight mode Setting the start and end timeTG4311BX.book Page 24 Monday, November 10, 2008 932 AM Caller list Using Caller ID serviceCaller ID features Ringer IDStoring your area code Editing a caller’s phoneNumber before calling back Erasing selected callerTG4311BX.book Page 27 Monday, November 10, 2008 932 AM Voice mail service Making an intercom call IntercomTransferring calls, conference calls Answering an intercom callHandset Press OFF Handset locatorBase unit Locator Wall mounting To remove the wall mounting adaptor Error messages Display message Cause/solutionPhonebook full Programmable settings Problem Cause/solution TroubleshootingGeneral use Problem Cause/solution Battery recharge Problem Cause/solutionProblem Cause/solution Making/answering calls, intercomCaller ID Problem Cause/solution Base unit Press and hold Locator Registration Problem Cause/solutionHandset Menu i#130 Liquid damage Problem Cause/solution Dial lock ImportantSpecifications Index TG4311BX.book Page 42 Monday, November 10, 2008 932 AM TG4311BX.book Page 43 Monday, November 10, 2008 932 AM Copyright PNQX1829ZA CC1108PA0For your future reference
Top Page Image Contents