Panasonic VL-MV30BX For your safety, Power connection, Installation, Operating safeguards

Page 4

Important Information

For your safety

To prevent severe injury and loss of life/property, read this section carefully before using the unit to ensure proper and safe operation of your unit.

WARNING

Power connection

LUse only the power source marked on the unit. If you are not sure of the type of power supplied to your home, consult your dealer or local power company.

LDo not place objects on the power cord. Install the unit where no one can step or trip on the cord.

LDo not overload power outlets and extension cords. This can result in the risk of fire or electric shock. LCompletely insert the power plug into the power outlet. Failure to do so may cause electric shock and/or

excessive heat resulting in a fire.

LRegularly remove any dust, etc. from the power plug by pulling it from the power outlet, then wiping with a dry cloth. Accumulated dust may cause an insulation defect from moisture, etc. resulting in a fire.

LUnplug this unit from power outlets if it emits smoke, an abnormal smell or makes unusual noise. These conditions can cause fire or electric shock. Confirm that smoke has stopped and contact an authorized service center.

LNever touch the plug with wet hands. Danger of electric shock exists.

Installation

LTo prevent the risk of fire or electrical shock, do not expose the product (excluding the door station) to rain or any type of moisture.

LDo not allow the power cord to be excessively pulled, bent or placed under heavy objects.

Operating safeguards

LTo reduce the risk of electric shock, do not disassemble this unit. Refer servicing to an authorized service center when service is required. Opening or removing covers may expose you to dangerous voltages or other risks. Incorrect reassembly can cause electric shock when the unit is subsequently used.

LDo not touch the main monitor station and the power plug during an electrical storm. There may be a remote risk of electric shock from lightning.

LNever push any objects through slots in this unit. This may result in the risk of fire or electric shock. Never spill any liquid on the unit.

LUnplug this unit from power outlets and refer servicing to an authorized service center when the following conditions occur:

A. If the power cord is damaged or frayed.

B. If metal objects have been dropped inside the main monitor station.

C. If the main monitor station has been exposed to rain or water, or liquid has been spilled into the unit. Do not use a microwave oven to speed up the drying process of any parts of the unit to avoid permanent damage.

D. If the unit has been dropped or physically damaged.

CAUTION

Installation and relocation

LThe power cord is used as the main disconnect device. Ensure that the power outlet is installed near the product and is easily accessible.

Operating safeguards

LDo not put your ear(s) near the speaker, as loud sounds emitted from the speaker may cause hearing impairment.

4

Image 4
Contents Attached Installation Guide Thank you for purchasing a Panasonic productIntroduction Important InformationPreparation RecordingAccessory information Additional/replacement accessoriesAccessory items Order number When using with a lobby stationFor your safety Power connectionInstallation Operating safeguardsFor best performance Important safety instructionsOther information Location of controls Main monitor stationMonitor display Operation guidance and button guidanceOperation guidance Button guidanceDoor station Monitor Setting the date and timeMenu Door KEY TALK/OFF When using an additional door station Answering a call by voice sensor Voice answer modeAnswering a call Features during a call or while monitoring Adjusting the display brightnessAdjusting the speaker volume Using Door KEY buttonWhen answering a call Monitoring the outside Door station monitor When installing 2 door stationsMonitor Menu TALK/OFF NAuto image update Recording an imageAuto recording To view recorded imagesManual recording PlayMenu Select Viewing recorded imagesNTo view the next image Unplayed Recording number Recording date and timeAdjusting the ringer volume MenuChanging the ringer tone Ringer tone patternsSound Sound 1 RepeatSetting Setting Door KEY buttonCurrent Changing the function settings Function list How to change the function settingsFunction list Monitor MenuRECORDING/PLAY Settings Play Lamp YES, no Flashing Picture RecordTiming Display ALWAYS, 3 SEC Recording DateOther Settings Operation ON, OFF Guide Settings Demo ModeDelete ALL Delete ALL PICTURES, Back Pictures LobbyExpanding your system with optional units System components as of November Video intercom systemUnits required to be installed Adding a door station Using with Panasonic PBXOperating the door opener Please use only a Panasonic PBXTroubleshooting Monitor display Problem Cause & SolutionConversation Problem Cause & Solution Station does not sound Others Problem Cause & SolutionCleaning Main monitor station VL-MV30BX SpecificationsDoor station VL-V566BX Function Settings Ltime and Date Settings Linitialize Settings Ldemo Mode Guide OFFLvoice Answer Lplay Lamp Flashing Incoming VOLPage For your future reference Attach your sales receipt here