Grandstream Networks HT-286 Daylight Savings Time, MAC Address, WAN IP Address, Product Model

Daylight Savings Time

Controls whether displayed time is daylight savings time or not. If set to “Yes” and the Optional Rule is empty, then the displayed time will be 1 hour ahead of normal time.

•The “Automatic Daylight Saving Time Rule” has the following syntax: o start-time;end-time;saving. Both start-time and end-time have

the same syntax: month,day,weekday,hour,minute o month: 1,2,3,..,12 (for Jan, Feb, .., Dec)

o day: [+-]1,2,3,..,31

o weekday: 1, 2, 3, .., 7 (for Mon, Tue, .., Sun), or 0 indicating daylight savings rule is based on the day of the month.

o hour: hour (0-23),

o minute: minute (0-59)

•If “weekday” is 0, it means the date to start or end daylight savings is the given date. The “day” value must not be negative.

•If “weekday” is not zero and “day” is positive, then daylight saving starts on the first “day” of the week (1st Sunday, 3rd Tuesday etc).

•If “weekday” is not zero and “day” is negative, then daylight savings starts on the last “day” of the week (last Sunday, 3rd last Tuesday etc).

•Daylight savings is in minutes. If preceded by a (-), then subtract the number of minutes.

The default value for “Automatic Daylight Saving Time Rule” is US time: “04,01,7,02,00;10,-1,7,02,00;60”.

Example: US/Canada, where daylight savings is applicable: 04,01,7,02,00;10,-1,7,02,00;60

Daylight savings starts from the first Sunday of April at 2AM and ends the last Sunday of October at 2AM.).

In addition to the Basic Settings configuration page, end users also have access to the Device Status page.

TABLE 9: HT–286 DEVICE STATUS PAGE DEFINITIONS

MAC Address	The device ID in HEX format. This is needed for ISP troubleshooting.
WAN IP Address	Shows WAN IP address of HT–286.
Product Model	Contains the product model info.
Software Version	Program: This is the main software release. Boot and Loader are seldom
	changed.
System Up Time	Shows system up time since the last reboot.
Registered	Indicates whether the HT–286 is registered to the service provider’s
	server.
PPPoE Link Up	Indicates whether the PPPoE connection is up if the HT–286 is connected
	to DSL modem.
NAT	Indicates the type of NAT the HT–286 is connected to via its WAN port.
	Based on STUN protocol.
Grandstream Networks, Inc.	HT–286 User Manual	Page 17 of 28
	Firmware 1.1.0.31	Last Updated: 1/2009