Dial Plan Dial Plan Rules | Grandstream Networks HT-502 manual

Refer to Use Target Contact

DTMF Payload Type

DTMF in-audio

DTMF via RFC2833

DTMF via SIP INFO

Send Flash Event

Enable Call Features

Offhook Auto-Dial

Default is NO. If set to YES, then for Attended Transfer, the “Refer-To” header uses the transferred target’s Contact header information.

Sets the payload type for DTMF using RFC2833.

Send DTMF as inband (in-audio).

Send DTMF via RTP (According to RFC 2833).

Send DTMF via SIP INFO message.

Default is No. If set to yes, flash will be sent as DTMF event.

Default is Yes. (If Yes, call features using star codes will be supported locally)

This parameter allows users to configure a User ID or extension number to be automatically dialed upon off-hook. Only the user part of a SIP address needs is entered here. The HT–502 will automatically append the “@” and the host portion of the corresponding SIP address.

Proxy-Require		SIP Extension to notify SIP server that the unit is behind the NAT/Firewall.

Use NAT IP		NAT IP address used in SIP/SDP message. Default is blank.

Distinctive Ring Tone Custom Ring Tone 1 to 3 with associate Caller ID: when selected, if Caller ID is configured, then the device will ONLY uses this ring tone when the incoming call is from the Caller ID. System Ring Tone is used for all other calls. When selected but no Caller ID is configured, the selected ring tone will be used for all incoming calls.

Disable Call Waiting

Disable Call Waiting Tone

Ring Timeout

No Key Entry

Timeout

Early Dial

Dial Plan Prefix

Use # as Dial Key

Default is No.

Default is No. This is to disable the stutter Call Waiting Tone when a Call Waiting call arrives. The CWCID will still be displayed.

Incoming call will stop ringing when not picked up given a specific period of time.

Default is 4 seconds.

Default is No. Use only if proxy supports 484 response. This parameter controls whether the phone will send an early INVITE each time a key is pressed when a user dials a number. If set to “Yes”, an INVITE is sent using the dial-number collected thus far; Otherwise, no INVITE is sent until the “(Re- )Dial” button is pressed or after about 5 seconds have elapsed if the user forgets to press the “Re-Dial” button. The “Yes” option should be used ONLY if there is a SIP proxy configured and the proxy server supports 484 Incomplete Address response. Otherwise, the call will likely be rejected by the proxy (with a 404 Not Found error).

This feature is NOT designed to work with and should NOT be enabled for direct IP-to-IP calling.

Sets the prefix added to each dialed number.

Allows users to configure the “#” key as the “Send” (or “Dial”) key. If set to “Yes”, “#” will send the number. In this case, this key is essentially equivalent to the “Dial” key. If set to “No”, this “#” key can be included as part of number.

	Dial Plan	Dial Plan Rules:-
		1.	Accept Digits: 1,2,3,4,5,6,7,8,9,0
		2.	Grammar: x - any digit from 0-9;
			a.	xx+ - at least 2 digit number;
			b.	^ - exclude;
			c.	[3-5] - any digit of 3, 4, or 5;

Grandstream Networks, Inc.				HT-502 User Manual	Page 25 of 35
				Firmware 1.0.0.39	Last Updated: 03/2007

Dial Plan

Dial Plan Rules:-