Wan Led, Lan Led, PHONE1 PHONE2 LED | Grandstream Networks HT-502

TABLE 2: DEFINITIONS OF THE HT–502 LEDS

	Power LED				Indicates Power. Remains ON when Power is connected and turned ON.

	WAN LED				Indicates LAN (or WAN) port activity.

	LAN LED				Indicates PC (or LAN) port activity.
					Indicate status of the respective FXS Ports-PHONE1 / PHONE2 on the back
	PHONE1 /
	PHONE2 LED				panel

Busy – ON (Solid Green)

Slow blinking FXS LEDs indicates voicemail for that port.

NOTE: All LEDs display green when ON. Slow blinking of Power, WAN and LAN LED together indicate the product in firmware upgrading or provision state

CONFIGURE YOUR ATA

The HT–502 is easy to configure using the embedded GUI pages and the following five (5) steps.

FIVE EASY STEPS TO CONFIGURE THE HT–502

1.Connect a standard touch-tone analog telephone (or fax machine) to first FXS port.

2.Connect another standard touch-tone analog telephone (or fax machine) to second FXS port.

3.Insert the Ethernet cable into the WAN port of HT–502 and connect the other end of the Ethernet cable to an uplink port (a router or a modem, etc.)

4.Connect a PC to the LAN port of HT–502.

5.Insert the power adapter into the HT–502 and connect it to a wall outlet.

FIGURE 2: CONFIGURING THE HT–502

Internet

ADSL/Cable

Modem Ethernet

Analog Phone

Analog Phone

Cordless

Phone

Cordless

Phone

z	Fax	Fax
z

Grandstream Networks, Inc.	HT-502 User Manual	Page 6 of 35
	Firmware 1.0.0.39	Last Updated: 03/2007