Icom IC-R20 instruction manual Priority watch operation, Select the desired memory channel

8 PRIORITY WATCH

■Priority watch operation

DMemory channel watch and memory scan watch qSelect VFO mode; then, set an operating frequency.

wSet the watching channel(s).

For memory channel watch:

Select the desired memory channel.

For memory scan watch:

Select memory mode, or the desired bank group; then, push [MODE SCAN] for 1 sec. to start memory/bank scan.

ePush [8 SET] for 1 sec. to enter set mode.

rRotate [R-DIAL]to select “PRIORITY WATCH,” then push [8 SET].

tRotate [R-DIAL]to turn the priority watch ON, then push [8 SET].

•Select “BELL” if the priority beep function is necessary.

[R-DIAL]	***-SET-MODE-***
	----------------
	>PRIORITY-WATCH
	-KEY-TOUCH-BEEP
	-BEEP-LEVEL
	-BACKLIGHT
	-POWER-SAVE
MODE	-NOISE-BLANKER
SCAN
MR	PRIORITY-WATCH
S.MW
	----------------
SET	-OFF
	>ON
8	-BELL

yPush [DUALWATCH] to exit set mode and start the watch.

•“PRIO” indicator appears.

•The receiver checks the memory/bank channel(s) every 5 sec.

•The watch resumes according to the selected scan resume con- dition. (p. 41)

•During priority watch

		-DUP TSQL		AFC	-DUP TSQL					AFC
MODE			FM ANL		MODE		FM ANL
439 975					145 870
				PSKIP					PSKIP
	√		PRIOµ	001	√			PRIOµ	001
Monitors VFO frequency					Pauses		on a memory
for 5 sec.					(bank)	channel when a
					signal is received.
• During priority watch with priority beep
		-DUP TSQL		AFC	-DUP TSQL					AFC
MODE			FM ANL		MODE		FM ANL
439 975					145 870
				PSKIP					PSKIP
	√		PRIOµ	001	√			PRIOµ	001

Emits beep and blinks “S” indicator when a signal is re- ceived on a memory (bank) channel.

uPush [DUALWATCH] to cancel the watch.

43