Icom IC-R20 VFO scan watch qSelect memory mode, While scanning memory/bank channels

DVFO scan watch qSelect memory mode.

•Select a memory bank, if desired.

wPush [MODE SCAN] for 1 sec. to start memory/bank scan, if desired.

While scanning memory/bank channels:

Starts memory/bank scan first. Memory/bank scan can- not be started after VFO scan is started.

ePush [8 SET] for 1 sec. to enter set mode.

rRotate [R-DIAL]to select “PRIO,” then push [8 SET]. tRotate to turn the priority watch ON, then push [8 SET].

•Select “BELL” if the priority beep function is necessary.

yPush [DUALWATCH] to exit set mode and start the watch.

•“PRIO” indicator appears.

uPush and hold [MODE SCAN] to enter scan type selection condition.

iRotate [R-DIAL]to select the desired scan type from

“ALL,” “BAND” and “PROG-xx (xx= 0–24).”

oRelease [MODE SCAN] to start the VFO scan watch.

•The receiver checks the memory channel(s) every 5 sec.

•The watch resumes according to the selected scan resume con- dition. (p. 41)

!0Push [DUALWATCH] to cancel the watch and scan.

PRIORITY WATCH 8

• During priority watch

		-DUP TSQL		AFC	-DUP TSQL					AFC
MODE			FM ANL		MODE		FM ANL
1888 888					145 870
				PSKIP					PSKIP
	√		PRIOµ	001	√			PRIOµ	001
Monitors VFO frequency					Pauses		on a memory
for 5 sec.					(bank)	channel when a
					signal is received.
											8
• During priority watch with priority beep
		-DUP TSQL		AFC	-DUP TSQL					AFC
MODE			FM ANL		MODE		FM ANL
1888 888					145 870
				PSKIP					PSKIP
	√		PRIOµ	001	√			PRIOµ	001

Emits beep and blinks “S” indicator when a signal is re- ceived on a memory (bank) channel.

44