Cobra Electronics CXR725 To recall a stored memory channel location, Entered mode functions

Page 10

Operation

Mode Functions

Introduction

 

 

 

Operation

Customer Assistance

Warranty

6.Choose one of the following:

a.Press the Channel Up or Channel Down button to select a CTCSS privacy code (01 through 38) for the channel.

b.Press the Lock/Enter button to switch from CTCSS to DCS. The DCS icon and privacy code numbers will flash on

the display. The Channel Up or Channel Down button can then be used to select a DCS privacy code (01 through 104) for the channel.

If “OFF” flashes in place of the privacy code numbers,

a privacy code is already set in the opposite (CTCSS or DCS) system. Press the Channel Up or Channel Down button to cancel the opposite code and select a privacy code from the active system for the selected channel.

7. Choose one of the following:

a. Press the Lock/Enter button to enter the channel/privacy

Mode Button

Memory Icon

Channel Buttons

To recall a stored memory channel location:

1.Press the Mode button until the Memory icon and the memory location number flash on the display.

2.Press the Channel Up or Channel Down button to select a memory location (0 through 9).

If a location has been programmed before, its associated channel/privacy code will be shown on the display.

3.Press the Talk button to return to Standby mode on the selected memory location.

A memory location can be reprogrammed at any time it is displayed and flashing. Press the Lock/Enter button to begin.

code in the selected memory location. Radio then proceeds

to next Memory location, which will blink.

b. Press the Mode button to enter the channel/privacy

code in the selected memory location and proceed to other

functions on the channel/privacy code displayed before you

entered mode functions.

c. Press the Talk button to enter the channel/privacy code in the

selected memory location and exit mode functions. Upon release

of the Talk button, the radio will enter Standby mode on the

channel/privacy code just entered.

While recalling a stored memory location, if you do not press any buttons for 15 seconds, your radio will automatically return to Standby mode on the channel/privacy code displayed before you entered mode functions.

14

Nothing Comes Close to a Cobra® 15

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Automated Help Desk Making Life Easier and SaferRadio while on the go QuestionsFeatures Product FeaturesWarranty and Trademark AcknowledgementCaring for Your microTALK Radio Avoid exposure to extreme temperaturesReplace battery compartment cover and belt clip Estimated operation time on full charge 10 hoursUsing Your Radio Turning on Your microTALK RadioListening for a Response Selectable HighLow Power OutputChannels To Illuminate DisplaySpeaker/Microphone/Charge Jack Signal Strength MeterAuto Squelch/Maximum Range MicroTALK RangeWill be displayed in the following order Mode FunctionsScrolling through Mode Functions Privacy CodesAfter selecting a channel, press Set Ctcss Privacy Codes To select a Ctcss privacy codeSet DCS Privacy Codes To select a DCS privacy code Voice Activated Transmit VOX Memory LocationsTo recall a stored memory channel location Entered mode functionsPress the Mode button to enter the channel/privacy To next Memory location, which will blinkChannel Scan If you press the Talk button while scanning, but more than Return to Standby modeTo scan privacy codes Memory Location Scan Press the Mode button Press the Mode button to proceed to other functionsTo change call settings Current settingTime you press a button or change a setting Mode Functions and General SpecificationsCall Tone Settings Unique call alert Keystroke TonesSafety Information for microTALK Radios General Specifications FCC LicenseNormal Position For Products Purchased in the U.S.A Product ServiceSend the entire product For Products Purchased Outside the U.S.A
Top Page Image Contents