Operation
Mode Functions
|
|
|
|
Introduction | Operation | Customer Assistance | Warranty |
During privacy code scan (while receiving an incoming transmission), you can choose from the following:
a. Press and hold the Talk button to communicate on that channel/privacy code. Your radio will remain on
that channel/privacy code and return to Standby mode.
b. Press the Channel Up or Channel Down button to resume scanning privacy codes.
If you press the Talk button while scanning, but more than 10 seconds
Memory Location Scan | • | |
Your microTALK radio can automatically scan up to | ||
| ||
10 programmed Memory Locations. |
| |
If there are one or fewer memory locations programmed |
| |
in your radio, the scan memory locations option will not be |
| |
available. To program at least two memory locations, see |
| |
program memory locations on page 13. |
|
after receiving a transmission, you will transmit on the channel/privacy code on which you last received a transmission. This will then return the
radio to Standby mode.
If you do not press any button within 10 seconds, your radio will automatically resume scanning privacy codes.
During privacy code scan (while not receiving a transmission), you can choose from the following:
a. Press and hold the Talk button to communicate on
the channel/privacy code that was displayed before you entered mode functions or the channel/privacy code on which, during scanning, you last received a transmission. This will return the radio to Standby mode.
b. Press the Mode button to proceed to set memory location scan (see page 21 for further details).
Mode Button
Scanning Locations
Channel Buttons
To scan memory locations:
1.Press the Mode button until the Scan icon, Memory icon and the memory location number flash on the display.
2.Press the Channel Up or Channel Down button to begin scanning memory locations.
The Scan icon and the Memory icon will continue to be displayed when memory
location scan is on. Your radio will continue
to scan memory locations and stop if an incoming transmission is detected. Your
radio will remain on that memory location for 10 seconds.
c. Press the Lock/Enter button to return to Standby mode on the channel/privacy code that was displayed before you entered mode functions or the channel/privacy code on which, during scanning, you last received a transmission.
While setting memory location scan, if you do not press any buttons for 15 seconds, your radio will automatically return to Standby mode on the channel/privacy code displayed before you entered mode functions.
20 | Nothing Comes Close to a Cobra® 21 |