Connection and Calibration
Lexicon
SILENCE
NOISE
Push PARAM UP again for RIGHT ONLY. If your left ear is in the silent band, the speaker angle is correct. Repeat for the right side.
If the two silent bands are too close, raise SPEAKER ANGLE; if too far apart, lower SPEAKER ANGLE.
To store, see page 29.
go on to step 6; otherwise, perform step 5.
5.Push PARAM twice so the display reads: SPEAKER ANGLE. If the sweet spot from step 2 (LEFT ONLY) is to the left of the sweet spot from step 4 (Right ONLY), push PARAM UP once. If the the step 2 sweet spot is to the right of the step 4 sweet spot, push PARAM DOWN. Push PARAM to return to CALIBRATE RIGHT ONLY and go back to step 2.
6.Adjust your chair so the single sweet spot is in the center, or use PARAM to get to LISTENER POS and adjust this parameter to move the sweet spot to where you want it. Use PARAM to step to CALIBRATE and push PARAM DOWN until the calibration signal goes off.
The Panorama Program is now calibrated. To store it, see page 27. Use PARAM to display the final values of LISTENER POS and SPEAKER ANGLE. Note these values and use them for all forms of Panorama, including the Panorama subsections of AMBIENCE and REVERB.
Page 12