3Com CP-1 owner manual Theory Design

Page 43

Theory

and

Design

CP-1 Digital Audio Environment Processor

quency.

Lexicon’s implementation, called the Panorama program, was designed using measured data on sound diffraction around the head to shape the frequency spectrum of the canceling signal. This signal is then itself canceled by a second signal, and so on, so that both the crosstalk and the

Speaker

Input

Higher order

Speaker

 

Level

Signal

Correction

Level

First order

L

 

 

R

 

 

Higher order

 

 

L

 

R

 

 

L

R

 

signal that is canceling it are eliminated.

This works extremely well when the room is well damped and the listener’s head is correctly positioned. The first order devices described earlier required the listener to sit on the center line between the loudspeakers, and to arrange the angle between the speakers to correspond to the pro- grammed delay. Although the CP-1 provides adjustments to compensate for off-center listening and for varying speaker angles, maintaining a consistent listening position is still important and becomes more so with increasing frequency. With wide speaker angles, a movement of as little as 1 inch can make a perceptible difference. Fortunately, the effect is usually fairly good everywhere within a zone about one foot wide.

To achieve the fullest Panorama effect, your main loudspeakers should have good imaging. The smaller speakers that tend to be used with video systems may have an inherent advantage here but the most important requirement is that the two speakers have identical frequency response and symmetrical dispersion. It is not necessary, or desirable, to turn your listening room into an anechoic chamber but moving the speakers away from the walls can be helpful, as can adding absorption (as provided by carpets, curtains and/or sound-absorbent panels) to reduce the reflectivity of the floor, walls and ceiling.

First order correction travels to left ear, where it will be heard unless canceled by an additional correction. When these higher order corrections are supplied, accurate cancellation is possible.

Page 39

Image 43
Contents Reverb Surround CP-1 Digital Audio Environment ProcessorOwners Manual Panorama AmbienceUnpacking and Inspection PrecautionsAcknowledgements Safety Suggestions Table of Contents Introduction ControlsFront Panel Controls IndicatorsSource Monitor Inputs Rear PanelPrograms Remote ControlPanorama Effect VolumeBank ParameterControls Indicators Connections to Other Equipment InstallationPrecautions Connection CalibrationConnection and Calibration Connecting the CP-1 in a Tape Monitor LoopAudio Inputs Input Levels Setting Main Input Output LevelsFront Panel Adjustments Connection CalibrationBalancing Additional Channels Output LevelsCalibration of the Panorama Program Silence Noise Configuration Speaker Set-Up ConfigurationSpeaker Configurations For Film Speaker Set-Up ConfigurationSpeaker Set-Up Configuration For Music Speaker Set-Up Configuration Speaker Set-Up Configuration Test Mode Using the 4 ProgramsTo Load, Modify and Store Programs Program Parameters PanoramaListener Position Rear Level Rear DelayEffect Level Input BalanceRoom Shape Liveness AmbiencePrograms Ambience Reverb Treble Pre-DelayMid RT Bass RTProgram Parameters Mono Logic SurroundPro Logic Stereo LogicRear Effect Program Parameters contd Auto AzimuthBalance Bass BlendNaming a Register Using ProgramsRestoring Original Settings To Rename and Store a RegisterUsing Programs Troubleshooting TroubleshootingProblem Troubleshooting Restoring defaults Troubleshooting Lateral Sound Theory DesignConcert Hall Acoustics Lateral Sound in your Listening Environment Theory and DesignAmbience Generation TheoryDesign Ambience ExtractionPanorama Program Theory Design Theory and Design Ambience Program Be the sound that comes from the sides Reverb Program Mono Logic Surround ProgramsPro Logic Pro Logic Decoding Dolby Surround DecodingCP-1 Decoder Stereo Logic Speaker Set-Ups for Pro Logic Theory and Design References Theory and Design Frequency Response SpecificationsOptional Equipment 06/00 Lexicon 070-06619 Rev