3Com CP-1 owner manual Rear Panel, Inputs

Page 7

Controls and

Indicators

CP-1 Digital Audio Environment Processor

The Rear Panel

	LEVEL
REAR	SIDE	MAIN	CENTER SUB	TAPE	TAPE
				OUT	IN
L		L	CENTER/OUT	L
	OUTPUTS		PHANTOM/IN
R		R		R
			SUB WOOFER

INPUTS

II I

L

R

Stereo outputs for rear and side power amplifiers, with level adjusting knobs. The procedure for balancing these outputs (as well as the center channel and subwoofer) with the main pair begins on page 9.

Main outputs, with level adjustment. Level-setting of these outputs must precede adjustment of the auxiliary channels.

The adjustment of the subwoofer output should be done only after all other channels are calibrated. (See page 11.)

Center channel output with level control and button. Push the button in if you have no center channel; leave it out if a center speaker is connected. NOTE: Leaving this button out with no center channel will cause the Surround programs to malfunction.

Inputs and outputs for an additional audio or video tape deck (audio portion only) or to replace the monitor loop occupied by the CP-1.

Rear and Side Outputs

Main, Center

and Subwoofer

Outputs

Center/Out

Phantom/In

Tape Out/In

Two sets of main inputs, selected by the SOURCE I/II buttons.

Inputs

Page 3

Image 7

Contents Reverb Surround CP-1 Digital Audio Environment ProcessorOwners Manual Panorama AmbienceUnpacking and Inspection PrecautionsAcknowledgements Safety Suggestions Table of Contents Introduction ControlsFront Panel Controls IndicatorsSource Monitor Inputs Rear PanelPrograms Remote ControlPanorama Effect VolumeBank ParameterControls Indicators Connections to Other Equipment InstallationPrecautions Connection CalibrationConnection and Calibration Connecting the CP-1 in a Tape Monitor LoopAudio Inputs Input Levels Setting Main Input Output LevelsFront Panel Adjustments Connection CalibrationBalancing Additional Channels Output LevelsCalibration of the Panorama Program Silence Noise Configuration Speaker Set-Up ConfigurationSpeaker Configurations For Film Speaker Set-Up ConfigurationSpeaker Set-Up Configuration For Music Speaker Set-Up Configuration Speaker Set-Up Configuration Test Mode Using the 4 ProgramsTo Load, Modify and Store Programs Program Parameters PanoramaListener Position Rear Level Rear DelayEffect Level Input BalanceRoom Shape Liveness AmbiencePrograms Ambience Reverb Treble Pre-DelayMid RT Bass RTProgram Parameters Mono Logic SurroundPro Logic Stereo LogicRear Effect Program Parameters contd Auto AzimuthBalance Bass BlendNaming a Register Using ProgramsRestoring Original Settings To Rename and Store a RegisterUsing Programs Troubleshooting TroubleshootingProblem Troubleshooting Restoring defaults Troubleshooting Lateral Sound Theory DesignConcert Hall Acoustics Lateral Sound in your Listening Environment Theory and DesignAmbience Generation TheoryDesign Ambience ExtractionPanorama Program Theory Design Theory and Design Ambience Program Be the sound that comes from the sides Reverb Program Mono Logic Surround ProgramsPro Logic Pro Logic Decoding Dolby Surround DecodingCP-1 Decoder Stereo Logic Speaker Set-Ups for Pro Logic Theory and Design References Theory and Design Frequency Response SpecificationsOptional Equipment 06/00 Lexicon 070-06619 Rev