!
The battery connector will fit together only one way. Make sure the connector is properly aligned. Use only the Uniden battery pack (model
!
It is recommended to place the handset on the base after use if convenient. However recharging the battery is only necessary when the low battery indicator is lit.
INSTALLING & CHARGING THE BATTERY PACK
Installing the Battery Pack
The rechargeable battery pack must be fully charged before using your phone for the first time. Before plugging the phone line into your new phone, you must charge the battery for approximately
1.Remove the Handset battery cover.
2.Plug the battery’s cable into the handset press the plug in firmly
until it clicks into place. Place the battery pack inside the battery compartment.
3. Replace the battery cover.
Charging the Battery Pack
▼Initial battery charging
Before connecting your the phone line for the first time, fully charge the rechargeable battery pack for
1.Place the handset on the base (facing up or down).
2. Make sure that charge LED lights. If the LED doesn’t light, be sure the AC
adaptor is plugged in and the handset | charge |
| |
makes good contact with the base |
|
charging contacts. |
|
▼Low battery indicator
The low battery indicator shows when the battery pack is very low and needs to be charged. If the phone is not in use, the batt low LED flashes every four seconds. If the phone is in use, the batt low LED flashes every four seconds and the handset beeps. Complete your conversation as quickly as possible and return the handset to the base for charging.
8