Uniden DG72 Adjusting Ringer Tone, Handset ringer volume, Press the vol, Handset earpiece volume

Page 13

▼ . To raise the

CLEANING THE BATTERY CONTACTS

To maintain a good charge, clean all charging contacts on the handset and base about once a month. Use a pencil eraser or other contact cleaner. DO NOT use liquids or solvents; you may damage your phone.

ADJUSTING THE VOLUME CONTROLS

▼Handset ringer volume

Press the vol

▼

or ▼ key on the handset

to set the handset ringer volume. There are two ringer volume settings; high and low.

▼Handset earpiece volume

There are four volume settings for the handset earpiece; max., high, low and min. The handset earpiece volume can be adjusted only during a call.

To lower the volume, press vol

volume, press vol

▼

The volume will remain on the same setting when you hang up.

ADJUSTING RINGER TONE

1.Press flash . button.

2.Press 1 , 2 , 3 or 4 on the keypad to select ringer tone.

Note: The procedure it the same for both the handset and base unit.

INSTALLATION & ADJUSTING

Image 13

Contents DG72 Choosing the best location for your telephone Installation & SafetyInstructions Start Adjusting the Handset Earpiece Volume Installing the Handset BatteriesTo Make a Call To Hang UpContents Talk LED Battery Low LED Battery Compartment Handset Antenna Talk ButtonBase Microphone Power LED Use/Hold/Mute LED Charge LED Controls & FunctionsWait Introduction FeaturesWelcome Enhanced Memory Dial Locations 16 digits maximum per memoryIntroduction Included in Your PackageRegistration Card Memory Stickers Wall Mounting ScrewsWall Installation InstallingBase Retainer holds the handset in place Installation & AdjustingInstalling the Battery Pack Installing & Charging the Battery PackCharging the Battery Pack Initial battery chargingHandset ringer volume Adjusting Ringer ToneHandset earpiece volume Volume will remain on the same setting when you hang upTo reset the digital security code Installing the BeltclipAutomatic Digital Code Security To attach the beltclipUsing Your Phone UsingMaking and Receiving Calls Basic phone operationUsing the Flash Key Using the c.wait featureUsing the c.wait or flash key Call WaitingIntercom MuteRoom Monitor Call TransferEntering Handset Memory Numbers Transferring a call from the Base Unit to the HandsetRedial/p to insert a pause Press mem againDialing a Number in Memory Using the memory location featuresChain Dialing From the HandsetPabx Connection Travelling OUT-OF-RANGEFrom the Base Unit Speaker on the base unitTroubleshooting Quick Reference ChartCharging contacts may need to be cleaned Second to reset the systemHandset rechargeable battery pack may need That they are pushed in firmly until they clickWarranty WarrantyWarrantor Uniden New Zealand LimitedThank YOU for Purchasing a Uniden Phone