PROBLEM | SUGGESTION | |
|
| |
| ● Check the telephone line cord connectors at both ends | |
| that they are pushed in firmly until they click. | |
No dial tone. | ● If you had a power failure or had unplugged the base | |
| unit, replace the handset on the base unit for two to five | |
| second to reset the system. | |
|
| |
| ● You may have exceeded the Ringer Equivalence Number | |
| (REN) limit of how many phones can be connected to the | |
Does not ring. | same line. The REN total of all devices (printed on the | |
label on the bottom of each unit) should not exceed three | ||
| ||
| (3). Disconnect the appropriate units to lower the REN | |
| total. | |
|
| |
| ● Check the battery pack connection inside the main battery | |
No power on | compartment on the handset. | |
handset unit | ● The handset rechargeable battery pack may need to be | |
| charged. | |
|
| |
| ● Make sure the charging contacts on both the base unit | |
| and the handset are in contact during charging. | |
Does not charge | ● The charging contacts may need to be cleaned. | |
| ● The battery pack may need to be discharged first before a | |
| full charge. | |
|
| |
| ● Raise or reposition the antenna on the base or handset. | |
Range is limited | ● Move the base unit so that it is centrally located in your | |
residence or office and make sure that the base unit is not | ||
| ||
| located near appliances. | |
|
| |
| ● The handset rechargeable battery pack may need | |
Calls received | charging. | |
| ||
flutters or fades | ● You may be out of normal operating range. Move closer to | |
| the base unit. | |
|
| |
| ● When storing phone numbers, make sure that the handset | |
Cannot store or | is in the standby position. | |
● When recalling stored phone numbers, check first for a | ||
recall phone | ||
dial tone. | ||
numbers from | ||
| ||
memory | ● Always use two digits when entering/recalling memory | |
| numbers. | |
|
|
18