Uniden DG72 Installing the Beltclip, Automatic Digital Code Security, To attach the beltclip

Page 14

INSTALLING THE BELTCLIP

To attach the beltclip.

Insert the beltclip into the empty slot and press down until it clicks.

To remove the beltclip

Pull back on the release tab and lift the beltclip up.

 

talk

batt low

talk

 

c.wait

 

redial/p

1

2 abc

3 def

4 ghi

5 jkl

6 mno

7 pqrs

8 tuv

9 wxyz

*flash

0

#

mem

mute

 

vol

 

AUTOMATIC DIGITAL CODE SECURITY

To prevent other parties from making unauthorised calls on your phone line, a digital code was added to the DG72. Your phone’s handset and base share this code. This code is randomly set each time you place the handset in the base. If the phone experiences a power failure, you must reset the digital security code by placing the handset on the base.

To reset the digital security code

1.Restore power to the base.

2.Place the handset on the base.

talk (on the handset) and

in use/hold/mute

(on the base) LEDs momentarily blinks. The digital security code is reset.

charge

in use/hold/mute

speaker

power

10

Image 14
Contents DG72 Instructions Installation & SafetyChoosing the best location for your telephone Start To Make a Call Installing the Handset BatteriesAdjusting the Handset Earpiece Volume To Hang UpContents Base Microphone Power LED Use/Hold/Mute LED Charge LED Battery Compartment Handset Antenna Talk ButtonTalk LED Battery Low LED Controls & FunctionsWait Welcome FeaturesIntroduction Enhanced Memory Dial Locations 16 digits maximum per memoryRegistration Card Included in Your PackageIntroduction Memory Stickers Wall Mounting ScrewsBase InstallingWall Installation Installation & Adjusting Retainer holds the handset in placeCharging the Battery Pack Installing & Charging the Battery PackInstalling the Battery Pack Initial battery chargingHandset earpiece volume Adjusting Ringer ToneHandset ringer volume Volume will remain on the same setting when you hang upAutomatic Digital Code Security Installing the BeltclipTo reset the digital security code To attach the beltclipMaking and Receiving Calls UsingUsing Your Phone Basic phone operationUsing the c.wait or flash key Using the c.wait featureUsing the Flash Key Call WaitingRoom Monitor MuteIntercom Call TransferRedial/p to insert a pause Transferring a call from the Base Unit to the HandsetEntering Handset Memory Numbers Press mem againChain Dialing Using the memory location featuresDialing a Number in Memory From the HandsetFrom the Base Unit Travelling OUT-OF-RANGEPabx Connection Speaker on the base unitQuick Reference Chart TroubleshootingHandset rechargeable battery pack may need Second to reset the systemCharging contacts may need to be cleaned That they are pushed in firmly until they clickWarrantor WarrantyWarranty Uniden New Zealand LimitedThank YOU for Purchasing a Uniden Phone