Uniden DG72 quick start Quick Reference Chart, Troubleshooting

Page 21

TROUBLESHOOTING

YOUR NEW PHONE

QUICK REFERENCE CHART

If your phone is not performing to your expectations, please try these simple steps first before calling Uniden customer service.

	PROBLEM	SUGGESTION

		● Make sure the AC adaptor is plugged into the base and
	The charge light	wall outlet.
	won’t come on	● Make sure the handset is properly seated
	when the handset	in base.
	is placed on	● Make sure the charging contacts on the handset and base
	the base.	are clean.

		● Make sure that the base antenna is in a vertical position.
	The audio sounds	● Move the handset and/or base to a different location away
	The audio sounds	from metal objects or appliances and try again.
	weak and/or	from metal objects or appliances and try again.
	weak and/or
	scratchy

		● Check both ends of the base telephone
		line cord.
		● Make sure the AC adaptor is plugged into the base and
		wall outlet.
	Can’t make or	● Disconnect the AC adaptor for a few minutes, then
	receive calls.	reconnect it.
		● Place the handset back on the charging cradle for a few
		seconds. The talk and in use/hold/mute
		LEDs blinks momentarily indicating that the phone has
		been reset.

		● The battery pack may be weak. Charge the battery for
		15-20 hours.
		● Be sure the antenna is in a vertical position.
	The handset	● The handset may be too far away from the base. Place the
	The handset	base away from appliances or metal objects.
	doesn’t ring or	base away from appliances or metal objects.
	doesn’t ring or	● Place the handset back on the charging cradle for a few
	receive a page.	● Place the handset back on the charging cradle for a few
	receive a page.	seconds. The in use LED lights indicating that the
		seconds. The in use LED lights indicating that the
		phone has been reset.
		● You may have exceeded the REN limit. Disconnect some
		telephones.

		17

TROUBLESHOOTING

Image 21

Contents DG72 Installation & Safety Choosing the best location for your telephoneInstructions Start Adjusting the Handset Earpiece Volume Installing the Handset BatteriesTo Make a Call To Hang UpContents Talk LED Battery Low LED Battery Compartment Handset Antenna Talk ButtonBase Microphone Power LED Use/Hold/Mute LED Charge LED Controls & FunctionsWait Introduction FeaturesWelcome Enhanced Memory Dial Locations 16 digits maximum per memoryIntroduction Included in Your PackageRegistration Card Memory Stickers Wall Mounting ScrewsInstalling Wall InstallationBase Retainer holds the handset in place Installation & AdjustingInstalling the Battery Pack Installing & Charging the Battery PackCharging the Battery Pack Initial battery chargingHandset ringer volume Adjusting Ringer ToneHandset earpiece volume Volume will remain on the same setting when you hang upTo reset the digital security code Installing the BeltclipAutomatic Digital Code Security To attach the beltclipUsing Your Phone UsingMaking and Receiving Calls Basic phone operationUsing the Flash Key Using the c.wait featureUsing the c.wait or flash key Call WaitingIntercom MuteRoom Monitor Call TransferEntering Handset Memory Numbers Transferring a call from the Base Unit to the HandsetRedial/p to insert a pause Press mem againDialing a Number in Memory Using the memory location featuresChain Dialing From the HandsetPabx Connection Travelling OUT-OF-RANGEFrom the Base Unit Speaker on the base unitTroubleshooting Quick Reference ChartCharging contacts may need to be cleaned Second to reset the systemHandset rechargeable battery pack may need That they are pushed in firmly until they clickWarranty WarrantyWarrantor Uniden New Zealand LimitedThank YOU for Purchasing a Uniden Phone