Uniden DX8200 manual Setting the Handset Retainer

Page 25

INSTALLATION

SETTING THE HANDSET RETAINER

The Handset Retainer holds the Handset in place if your phone is mounted on a wall. These steps describe how to remove and replace the retainer so that the tab faces up.

1.Push up on the Handset Retainer on the Base Unit and slide the tab out.

2.Flip the Retainer over so the tab faces up, then put the Retainer back into it slot on the Base Unit.

3.Push down on the Handset Retainer until it snaps into place.

INSTALLATION

25

Image 25

Contents DX8200 This page intentionally left blank Contents Contents Important Safety Instructions Safety InformationBattery Safety Precautions Safety InformationRechargeable NICKEL-CADMIUM Battery Warning PrecautionsImportant Electrical Considerations Telephone Line ProblemsRange Radio InterferenceCordless Telephone Privacy More Than One Cordless TelephoneThis page intentionally left blank Introduction Important Notice IntroductionParts Checklist Parts Checklist For Australian ModelsParts Checklist For New Zealand Models Parts ChecklistDX8200 Features FeaturesThis page intentionally left blank Handset FunctionsBase Unit FunctionsConnecting the Telephone Cords InstallationSelecting a Location Telephone Line OutletsApplying Power to the Base Unit InstallationDesk or Tabletop Installation Plug the telephone line cords into the base unit as shown Direct Wall Mounting Installation Installation Setting the Handset Retainer This page intentionally left blank Installing the Handset Battery Pack Setting UP Your PhoneExtending the Base Antenna Charging the Battery Pack Setting UP Your PhoneInitial Battery Charging Place the Handset on the cradle Battery Memory Effect LOW Battery IndicatorAdjusting Ringer Volume Controls Cleaning the Battery ContactsAutomatic Digital Code Security Setting UP Your Phone This page intentionally left blank Storing Memory Dial Numbers Programming Your DX8200Entering Base Unit Memory Numbers Entering Handset Memory Numbers Programming Your DX8200Programming Entering Handset Tone/Pulse Memory Numbers Entering Base Unit Tone/Pulse Memory NumbersErasing Base Unit Memory Numbers Erasing a Stored NumberErasing Handset Memory Numbers This page intentionally left blank Answering a Call from the Base Unit Using Your DX8200Answering a Call from the Handset Making a Call from the Base Unit Using Your DX8200Making a Call from the Handset TWO-LINE OperationDialing Base Unit Memory Numbers Dialing Stored NumbersDialing Handset Memory Numbers Chain Dialing Using the Flash Button New Zealand Model onlyPlacing a Call on Hold Party Conferencing Last Number RedialPaging from the Base Unit to the Handset Using Your DX8200 IntercomPaging from the Handset to the Base Unit Call TransferTransferring a Call from the Base Unit to the Handset Using the DX8200 AS a Room MonitorAutomatic Channel Scan Feature Using the page FeatureChannel Button SpeakerphoneProblem Suggestion TroubleshootingThis page intentionally left blank Specifications For Australian Models Power Source SpecificationsOne-Year Limited Warranty WarrantyUDZZ01612BZ