Uniden EXS 9950 manual Direct wall plate mounting

If you have wall mounted the base, you must remove the beltclip to charge the handset facing forward.

8

Handset retainer

9

On the base unit, pull the handset retainer out of the slot. Rotate it clockwise

180 degrees.

Flip the retainer from front to back. Slide it back into the slot so that the lip of the retainer is up and the oval is down. The retainer holds the handset

in place.

Direct wall plate mounting

If you don't have a standard wall plate, you can mount your phone directly to the wall. Before doing this, consider the following:

•Avoid electrical cables, pipes, or other items behind the mounting location, that could cause a hazard when inserting screws into the wall.

•Try to mount your phone within 10 - 15 feet of a working phone jack to avoid excessive cord lengths.

•Make sure the wall material is capable of supporting the weight of the base and handset.

TOP		1 Insert two mounting screws
	3/16 in.
		into the wall, (with their
		appropriate anchoring device),
		3-15/16 inches apart. Allow
		about 3/16 of an inch between
	3-15/16 in.	the wall and screwheads for
		mounting the phone.
		2 Refer to steps 1 through 9 on
		page 8 and 9 to mount the
		telephone.

9