iSymphony V1BLUE Connect the Wireless iPod Dock to Power, Install Batteries into Remote

3Connect the Wireless iPod Dock to Power

This AC adapter operates on AC 120V/60Hz.

!	The included AC adapter is for use with
	this iPod dock only. Do not use it with
	other equipment.
	When the iPod dock is not going to be
	used for a long time, disconnect the AC
	adapter from the AC outlet.

To “DC IN

10V” jack To AC outlet

5Install Batteries into Remote

Insert two AAA batteries into the remote control while observing the correct (+) and (-) polarities as shown.

6Power on the Main Unit

Press the STANDBY / button. The main display briefly shows “HELLO” then “AM 12:00”. Please refer to page 51 for setting the clock.

4Select the Correct iPod Dock Adapter

!When connecting an iPod to this iPod Dock, please ensure that the correct adapter plate is used. FAILURE TO DO SO MAY RESULT IN DAMAGE TO THE iPod.

This iPod Dock comes with 4 removable dock adapters. Using the correct adapter ensures the proper fit for your iPod and helps to reduce the stress on the connector when operating the iPod.

NOTE: The adapter for iPod nano is already installed in the dock.

To place a dock adapter:

1.Refer to the compatibility table on page 39 and select the correct dock adapter for the iPod.

2.Place the proper adapter into the dock and press it into position. The adapter will only go in one way. The iPod dock connector should fit through the opening in the bottom of the adapter.

3.Carefully align and then gently insert the iPod into the dock. (The iPod must not be in a case or “skin”).

4.To remove a dock adapter, first remove the iPod, then grip the insert and pull gently upwards.

For setup of Bluetooth connections, refer to page 29.

To connect optional components see section Connecting External Devices page 51.

For setup of wall mount refer to page 53.