MP7610
Preparation (continued)
Install Half-Sleeve
1.Install adapter and dash kit if necessary (optional).
2.Install
3.Push tabs out to secure
4.Install support strap to make unit more stable.
Wiring
Wiring with a Wiring Adapter (Purchased Separately)
Connect Wires
You can make all these connections without even being in the car.
1.Splice or crimp wires.
2.Attach wiring adapter to car wiring harness.
Wiring Diagram / Color Codes
1.Power Antenna (dark blue wire) - Connect to power antenna or amplifier. If not used, tape bare end of wire.
2.Ground (black wire) - Connect to ground terminal or clean, unpainted part of chassis.
3.Memory/Battery (yellow wire) - Connect to battery or 12 volt power source that is always alive. The radio will not work if this wire is not connected.
4.Accessory/Ignition (red wire) - Connect to existing radio wire or radio fuse.
5.Left front speaker
6.Right front speaker
7.Left rear spearker
8.Right rear speaker
9.RCA Outputs to Amplifier
10.Auxiliary Input Cable (yellow)
11.Subwoofer Output (blue
12.Antenna
13.CD Changer
Fuses
When replacing a fuse, make sure the new fuse is the correct type and amperage. Using an incorrect fuse could damage radio. The MP7610 uses one 15 amp fuse located below the wiring connector: 15 amp fast blow ATO.
Reconnect Battery
When wiring is complete, reconnect the battery negative terminal.
Install | Connect Wires |
Instalación de la Camisa | Conecte los cables |
Installation du | Raccordement des fils |
| Jensen Connector |
| 4 |
3 |
|
| 1 |
| 1 |
| 2 |
2 |
|
Wiring |
|
Cableado |
|
Câblage |
|
10A |
|
11 |
|
| 12 |
10 |
|
| 13 |
Front | Black |
| |
Frente |
|
Avant | Negro / Noir |
| |
9 |
|
Rear | Gray |
Posterior |
|
Arrière | Gris / Gris |
White/Black
Blanco/Negro
Blanc/Noir
5
White / Blanco / Blanc (+)
Green/Black
Verde/Negro
Vert/Noir
7
+
Gray/Black
Gris / Negro
Gris / Noir
6
Gray / Gris / Gris (+)
Violet/Black
Violeta/Negro
Violet/Noir
8
1
2
3
4
Green / Verde / Vert (+) | Violet / Violeta / Violet (+) |
3