Heat Controller RAD-101A, RAD-81A manual Air Handling Parts, AIR Guide and Blower, FAN and Shroud

Disassembly

AirHandlingParts

1. AIR GUIDE AND BLOWER

1.	Remove the front grille.
2.	Remove the cabinet.
3.	Remove the control box.
4.	Remove the 3 screws which fasten the brace.
5.	Remove the brace.
6.	Remove the 2 screws which fasten the evaporator.
7.	Move the evaporator forward and pulling it upward
	slightly. (See Figure 20)
8.	Move the evaporator to the left carefully.	Figure 20

9.Pull out the hook of orifice by pushing the tabs and remove it. (See Figure 21)

10. Remove the clamp with a hand plier which secures the blower.

11. Remove the blower.

12. Remove the 4 screws which fasten the air guide from the barrier.

13. Move the air guide backward, pulling out from the base pan.

14. Re-install the components by referring to the removal procedure, above.

Figure 21

2. FAN AND SHROUD

1. Remove the cabinet.

2. Remove the brace.

3. Remove the 3 screws which fasten the condenser.

4. Move the condenser to the left carefully.

5. Remove the clamp which secures the fan.

6. Remove the fan and then pull out the shroud. (See Figure 22)

7. Re-install by referring to the removal procedure.

Figure 22

18Room Air Conditioner

—7—