Installation
3.Loosely assemble the Sill Support using the parts in Figure 7.
4.Select the position that will place the Sill Support near the outer most point on sill (See Figure 8)
NOTICE Be careful when you install the cabinet (Frame
Guides are broken so easily).
5.Attach the Sill Support to the cabinet track hole in relation to the selected position using 2 Type A screws in each support(See Figure 8).
6.The cabinet should be installed with a very slight tilt(about 1/2") downward toward the outside (See Figure 9).
Adjust the bolt and the nut of Sill Support for balancing the cabinet.
7.Attach the cabinet to the window stool by driving the screws (Type B: Length sixteen millimeters and below.) through the front angle into window stool.
8.Pull each Frame Curtain fully to each window sash track, and repeat step 2.
INDOOR | OUTDOOR |
Sill Support
Bolt | Nut |
Figure 7 | |
Frame Guide | Screw(Type A) |
| About 1/2" |
| Cabinet |
INDOOR | OUTDOOR |
| Figure 8 |
Screw(Type B) | Screw(Type A) |
| About 1/2" |
| Sill support |
| Sash track |
| Front Angle |
Sill support | Screw(Type B) |
Figure 9 |
9.Attach each Frame Curtain the window sash using screws (Type C).(See Figure 10)
CAUTION: DO NOT DRILL A HOLE IN THE BOTTOM PAN.
The unit is designed to operate with approximately 1/2" of water in bottom pan.
Type C
Figure 10
Service Manual 13