Installation procedure

indoor unit

Installation of indoor unit

Selection of installation place

Place where it is easy to route drainage pipe and outdoor piping. Place away from heat source and with less direct sunlight.

Place where cool and warm air could be delivered evenly to every corner of the room. Place near power supply socket. Leave enough space around the unit (refer to installation drawings).

Fixing of the unit

1.Position of the wall hole

Wall hole should be decided according to installtion place and piping direction. (refer to installation drawings)

2.Making a wall hole

Drill a hole of 70mm dia. with a little slope towards outside. Install piping hole cover and seal it with putty after installation.

INDOOR

wall hole

70mm

OUTDOOR UNIT

wall thinkness

Fixing of indoor unit	( Cross section of wall hole )

To prevent it from fall off, please fix the unit with fall-prevention fitting at wall and L-shaped metal at floor.

Self-tapping	all-prevention fitting metal (accessory)
screw	all-prevention fitting metal (accessory)
screw	Wood screw
	Wood screw
		Please install the whole
		unit horizontally,with a slop
		of 1 degree at front and
	L-shaped metal	rear,left and right.
	(accessory)