Operation
AUTO, COOL , HEAT and DRY Operation
LOCK
MODE TEMP
TEMP
FAN ON/OFF
4 5
1. Unit start
Press ON/OFF button,unit starts.
Previous operation status appears on LCD (except for TIMER,SLEEP and SWING setting)
2.Select operation mode
Press MODE button. At each press, operation mode changes as follows:
AUTO COOL DRY HEAT FAN
Then select AUTO run or select COOL operation or select DRY operation or select HEAT operation or select FAN operation
3.Temperature setting
Press TEMP button.
Every time the button is pressed, temp. setting increases 1 C; if the button is kept pressed, temp. setting will increase quickly.
Every time the button is pressed, temp. setting decreases 1 C, if the button is kept pressed, temp. setting will decrease quickly.
Set proper temperature
4.Adjust FAN button
Press FAN button. At each press, fan speed changes as follows:
AUTO(Flash) LOW | MID | HIGH |
Air conditioner will run at the selected fan speed.
COOL operation starts when room temp.is higher than temp. setting.
Temp. setting +2
C
Temp.setting
5. Unit stop
Press ON/OFF button,unit stops.
On reaching temp.setting +2 C, unit will run in mild DRY mode.
In FAN mode, the temperature setting is not displayed on LCD,and "Auto Fan" not available.
In DRY mode, when room temperature becomes 2 C higher than temperature setting, unit will run intermittently at LOW speed regardless of FAN setting. When room temperature is lower than temperature setting, unit will only run FAN operation.
In HEAT mode,warm air will blow out after a short period of time due to
5