7.NOTES ON OUTDOOR INSTALLATION
•Be sure to mount the speaker in a vertical
•Adjust the speaker's tilt angle within the shaded range shown below:
[Wall and pole: 0º horizontal to 45º downward] | [Under eaves: 15º downward to 45º downward] |
Note
Mount the speaker so that its
Note
The speaker faces 15° downward when mounting to a horizontal surface.
0º |
(horizontal) |
45° |
15°
0°
(horizontal)
(30°)
45°
•Install the speaker in locations exposed to an ambient temperature range of
•Use the supplied terminal cover when connecting the speaker cable.
[Terminal Cover Use]
3 | 2 | |
Terminal cover (accessory) | ||
| ||
| Tapping screw 4 x 12 (accessory) |
4 Bushing*
1
Speaker cable
Input terminal
[Stripped conductor]
10 mm
30 mm
Speaker unit
* Screwed onto the Terminal cover at the factory.
Notes
•For the speaker cable, use a cable with a diameter of 6 – 10 mm, which will fit the cable bushing.
•To ensure waterproof capabilities, firmly mount the terminal cover to the speaker and tighten the bushing on the cover.
Step 1. Feed the speaker cable through the bushing and terminal cover, then connect the cable to the input terminal.
Step 2. Attach the terminal cover to the speaker.
Attach the cover while pulling the cable so that it is not entangled inside the terminal cover.
Step 3. Hold the terminal cover tightly to the speaker using the supplied screws.
Step 4. Tighten the bushing.
Note
After tightening the bushing by hand, use a tool to further tighten it another 90º
6