Ericsson LBI-39110 EXT MIC Handsfree, Unit. To enable the external mic, press, Simplex, Mute

Page 23

after a preset time-out or can be removed from the

display by pressing . Call timer can be

refresh by pressing followed by . Time of the last interconnect call will be displayed.

4/EXT MIC (HANDSFREE)

The external mic (Handsfree) option routes audio to an external Portable or Vehicle Handsfree

unit. To enable the external mic, press

followed by . Toggling this function provides the user with the capability to have private conversations or allow other passengers in the vehicle to participate in the conversation (Vehicular Option). The character display shows "INT MIC" if the internal speaker/mic is currently active. To toggle the state to the external speaker/mic press

key twice while the FCN icon is on. (NOTE: With an external device connected the Allegra will always “power-up” with the external unit enabled.)

5/SIMPLEX

When operating in the simplex mode, the MUTE icon follows the state of the transmit audio. While in simplex mode, PTT must be pressed prior to speaking. (NOTE: Applicable only in the interconnect mode.)

6/MUTE

This function enables the user to mute the transmit audio when operating in the duplex mode. To disable the microphone so the called party

cannot hear the conversation, press

followed by . MUTE is displayed. Re-enable the microphone using the same key press sequence. The call is muted only for the duration of the current interconnect call.

23

Image 23

Contents Operators Manual Table of Contents Table of Contents Important Safety Information Explosive Atmospheres Safety InformationProduct has been exposed to rain or moisture or List of possible hazards followsRadio Frequency Energy Liquefied LP Gas Powered VehiclesOperating Procedures Dynamite Blasting CapsPage Introduction Page Momentarily Press User Interface ButtonKeypad Function PortionRecalls numbers from memory locations Numeric Portion Volume UP ButtonVolume Down Button Extended FeaturesLocks the radio Enables/disablesFor placing/storing Duplex operationServ Status IndicatorsFCN PWRCall Queued Not used Indicates the radio’s keypad is lockedAlert Tones Edacs Applications Call Originate AlertOUT of Range System Inoperative AutokeySystem Busy Call DeniedEdacs Operation Volume AdjustOperation General Turning The Radio ON/OFFGroup Selection-Direct Number Entry KeySystem Selection-Direct Number Entry Group Selection-Ramping NamesRedial Key Locking The RadioProgrammable Flex Keys Interconnect DialingStoring An Individual Call ID Using Special Call ListsIndividual Call Notification System Key usage Storing a Telephone Number To The Call ListRecalling calls from the call list Simplex OperationAlert Key Call TimerCLR key Usage Last Digit Clear And Display Clear Mute Unit. To enable the external mic, pressEXT MIC Handsfree SimplexPause ScanScan ADD/DELETE SPCCall Time-outs Carrier Control Timer CCTOperator enters or . The length of pause is PC programmable Programmable OptionsRx Disable-Group Option Automatic LoginSupervisory Mode TX Disable-Group OptionControl Channel Limits Cleaning InstructionsBattery Voltage Indicator Low Battery AlarmStandard Battery Removal Insertion Care and MaintenanceInserting and Removing a Battery Slide Indicator Optional High Capacity Battery RemovalPlug the AC converter into an AC outlet Using Rapid Multi-ChargerCharging a Battery Out of the Phone RechargingCharging While the Battery is in the Phone Charging Your BatteryUsing the Rapid Travel Charger Locate the end of the battery with round charging contactsRemoving Battery Allow the radio to remain on until it turns itself off Using Smart Charging AccessoriesRestoring Battery Capacity Option MAh Standard BatteryAvailable Options Frequently Called Numbers Page Page Page Warranty Emergency Numbers