Ericsson LBI-39110 manual Storing a Telephone Number To The Call List, Simplex Operation

Page 21

Storing A Telephone Number To The Call List

The number of dial locations (10, 20, 30, 40, or 50) available is set through radio programming. The maximum number of digits stored in any location is 14. The user may dynamically add phone numbers to the call list by following these steps:

1.Enter the phone number, then ,

followed by .

2.Enter the two digit storage location for the number (00 to 50).

The new phone number is now added to the call list at the specified location.

Recalling calls from the call list

Each pre-stored call number has a corresponding phone number. To dial the phone number, select the 2 digit call number and press

. Alternately, the user can scroll through the

call list using the key to scroll forward through the list.

Simplex Operation

The user can choose to terminate duplex operation and still maintain the interconnect call in

progress by pressing followed by . This key sequence toggles between simplex and duplex operation.

*/System Key usage

The /System ramp button is used in multiple contexts. When pressed while in monitor mode (i.e. radio is not in a special or interconnect call) the radio ramps through available systems in

one direction. If followed by /System is pressed, system ramping takes place in the opposite direction. If this key is pressed

after any key other than the is returned.

21

Image 21

Contents Operators Manual Table of Contents Table of Contents Important Safety Information Product has been exposed to rain or moisture or Safety InformationList of possible hazards follows Explosive AtmospheresOperating Procedures Liquefied LP Gas Powered VehiclesDynamite Blasting Caps Radio Frequency EnergyPage Introduction Page Keypad User Interface ButtonFunction Portion Momentarily PressRecalls numbers from memory locations Volume Down Button Volume UP ButtonExtended Features Numeric PortionFor placing/storing Enables/disablesDuplex operation Locks the radioFCN Status IndicatorsPWR ServAlert Tones Not used Indicates the radio’s keypad is lockedEdacs Applications Call Originate Alert Call QueuedSystem Busy AutokeyCall Denied OUT of Range System InoperativeOperation General Volume AdjustTurning The Radio ON/OFF Edacs OperationSystem Selection-Direct Number Entry KeyGroup Selection-Ramping Names Group Selection-Direct Number EntryProgrammable Flex Keys Locking The RadioInterconnect Dialing Redial KeyUsing Special Call Lists Individual Call NotificationStoring An Individual Call ID Recalling calls from the call list Storing a Telephone Number To The Call ListSimplex Operation System Key usageCall Timer CLR key Usage Last Digit Clear And Display ClearAlert Key EXT MIC Handsfree Unit. To enable the external mic, pressSimplex MuteScan ADD/DELETE ScanSPC PauseOperator enters or . The length of pause is PC programmable Carrier Control Timer CCTProgrammable Options Call Time-outsSupervisory Mode Automatic LoginTX Disable-Group Option Rx Disable-Group OptionBattery Voltage Indicator Cleaning InstructionsLow Battery Alarm Control Channel LimitsCare and Maintenance Inserting and Removing a BatteryStandard Battery Removal Insertion Slide Indicator Optional High Capacity Battery RemovalCharging a Battery Out of the Phone Using Rapid Multi-ChargerRecharging Plug the AC converter into an AC outletCharging While the Battery is in the Phone Charging Your BatteryLocate the end of the battery with round charging contacts Removing BatteryUsing the Rapid Travel Charger Using Smart Charging Accessories Restoring Battery CapacityAllow the radio to remain on until it turns itself off MAh Standard Battery Available OptionsOption Frequently Called Numbers Page Page Page Warranty Emergency Numbers