Ericsson LBI-39110 Operation General, Turning The Radio ON/OFF, Volume Adjust, Edacs Operation

Page 17

OPERATION

GENERAL

Turning The Radio ON/OFF

The radio is powered ON by pressing and

holding the button. All status indicators turn on momentarily and after 2 seconds a short beep will be heard and a message “---ON---”will be displayed on the LCD. A self diagnostic test is performed when the radio is first turned on if enabled through programming. To turn the radio

OFF press and hold the button again. After 2 seconds a short beep will be heard and a message “TURN OFF” will be displayed on the LCD. When turned off, the radio retains the last user selections (unless programmed for a particular power up option).

Additionally, the key is used to terminate interconnect and individual calls.

Volume Adjust

The user can adjust the volume at any time

using the and buttons. If the volume is adjusted while a call is in progress, no audible beeps are heard. If no call is in progress, a short beep is heard, in addition to the visual indication, if enabled. Additionally, the user selected “off-hook” volume level is saved separately from the user selected “on-hook” volume level.

EDACS OPERATION

System Selection-Ramping Names

The operator can ramp through the programmed system names list by pressing and

releasing the key.

If the radio is programmed for a non-split display then the selected talk group is displayed

when the radio is idling. The first time the

key is pressed the radio displays the selected system name. This name remains on the display

17

Image 17

Contents Operators Manual Table of Contents Table of Contents Important Safety Information Product has been exposed to rain or moisture or Safety InformationList of possible hazards follows Explosive AtmospheresOperating Procedures Liquefied LP Gas Powered VehiclesDynamite Blasting Caps Radio Frequency EnergyPage Introduction Page Keypad User Interface ButtonFunction Portion Momentarily PressRecalls numbers from memory locations Volume Down Button Volume UP ButtonExtended Features Numeric PortionFor placing/storing Enables/disablesDuplex operation Locks the radio FCN Status Indicators PWR ServAlert Tones Not used Indicates the radio’s keypad is lockedEdacs Applications Call Originate Alert Call QueuedSystem Busy AutokeyCall Denied OUT of Range System InoperativeOperation General Volume AdjustTurning The Radio ON/OFF Edacs OperationSystem Selection-Direct Number Entry KeyGroup Selection-Ramping Names Group Selection-Direct Number EntryProgrammable Flex Keys Locking The RadioInterconnect Dialing Redial KeyStoring An Individual Call ID Using Special Call ListsIndividual Call Notification Recalling calls from the call list Storing a Telephone Number To The Call ListSimplex Operation System Key usageAlert Key Call TimerCLR key Usage Last Digit Clear And Display Clear EXT MIC Handsfree Unit. To enable the external mic, pressSimplex MuteScan ADD/DELETE ScanSPC PauseOperator enters or . The length of pause is PC programmable Carrier Control Timer CCTProgrammable Options Call Time-outsSupervisory Mode Automatic LoginTX Disable-Group Option Rx Disable-Group OptionBattery Voltage Indicator Cleaning InstructionsLow Battery Alarm Control Channel LimitsStandard Battery Removal Insertion Care and MaintenanceInserting and Removing a Battery Slide Indicator Optional High Capacity Battery RemovalCharging a Battery Out of the Phone Using Rapid Multi-ChargerRecharging Plug the AC converter into an AC outletCharging While the Battery is in the Phone Charging Your BatteryUsing the Rapid Travel Charger Locate the end of the battery with round charging contactsRemoving Battery Allow the radio to remain on until it turns itself off Using Smart Charging AccessoriesRestoring Battery Capacity Option MAh Standard BatteryAvailable Options Frequently Called Numbers Page Page Page Warranty Emergency Numbers