8/SCAN
Scan operation is controlled by this key
sequence (i.e. 
followed by 
/SCAN). Display will read “SCAN ON” or “SCAN OFF”. (Note: Scan must be off to add/delete groups).
9/SCAN ADD/DELETE
Note: scan must be turned off before editing the scan list. To edit the scan list, press 
followed by 
. The upper display line will
show “SCAN A/D”. Press 
again. The display should change to the current group name.
Press | to ramp up to the group to be |
changed. Then press 
to ramp through the scan options. For a trunked system, these options are “not in scan” and “in scan”. For a conventional system, the options are “not in scan”, “in scan” a “priority 2 channel”, or a “priority 1 channel”. The scan state replaces the first two letters of the group name. The complete group name means the group is “not in scan”. A display line beginning
with “S” means the group is “in scan”. To exit,
press the 
key.
0/SPC
Entering 
followed by 
/SPC accesses the Special Call List. This list is a programmable set of call numbers that the user can invoke by scrolling to the desired call number in the
by pressing 
/GROUP. Scrolling backward
through this list is done by pressing
followed by 
/GROUP. (See Special PC programming functions in
Special Call List access by pressing 
.
Pause
A pause is entered into a stream of DTMF numbers being dialed via the keypad. The
24