Operation, Setting the Squelch, Monitor

UNIDEN Model uh015sx UHF CB Radio

Operation

Setting the Squelch

Turn the Unit ON by rotating the volume control clockwise. The uh015sx has 3 preset squelch levels:

1 - max sensitivity (min squelch)

2 - med sensitivity (med squelch)

3 - min sensitivity (max/tight squelch) It requires no adjustment.

AN	SRCH	MON	HOLD	POL
GS	BAND/TSQ	SQL	DCS/CTCSS	MEM

Press and hold MON . The squelch will flash.

Turn rotary knob to select. Press MON to set.

The SQT icon appears if level 3 is selected.

!Selecting tight squelch mode may prevent the reception of weak signals.

! High noise areas may still break the squelch.

Monitor

Press MON to open the squelch and receive all weak signals.

Press MON again momentarily to cancel.

MENU	SCAN	SRCH	MON	HOLD	POL
ENTER	OS/GS	BAND/TSQ	SQL	DCS/CTCSS	MEM

Selecting a Channel/POLICE and CB Channel Groups

Turn the Rotary Channel Selector to select the desired channel.

The uh015sx has two groups of channels to select from. When the CB icon is showing the 40 UHF-CB and any user programmed RX channel will be available for selection or scanning. When the POLICE icon is showing then the 115 police frequencies will be available. Press POL to select which group(s) to activate or deactivate.

For your reference a list of the available UHF CB channels, corresponding frequencies and guidelines for their use is printed on page 36. For Australia, Channels 05 and 35 are reserved for Emergency Calls.

MENU	SCAN	SRCH	MON	HOLD	POL
ENTER	OS/GS	BAND/TSQ	SQL	DCS/CTCSS	MEM

The 40 UHF-CB channels are numbered 1-40. The programmable RX channels are numbered 41-100 (100 is shown as o0) - and only show when programmed. The 115 police frequencies do not have channel numbers but you can still select them ( - - appears in the channel display) or copy them to a programmable RX channel.