Features, Preventative Maintenance | Uniden UH015sx guide

UNIDEN Model uh015sx UHF CB Radio

Introduction

The Uniden uh015sx is designed to provide you with years of trouble free service. Its rugged components and materials are capable of withstanding harsh environments. Please read this Operating Manual carefully to ensure you gain the optimum performance of the unit.

The citizen band radio service is licenced in Australia by ACMA Radio-communications (Citizen Band Radio Stations) Class Licence and in New Zealand by MED General User Licence for Citizen Band Radio and operation is subject to conditions contained in those licenses.

Features

!Detachable Display Unit

!Transmit & Receive FM 40CH (UHF-CB, TX Power 5W)

!60 Programmable RX Channels

!115 Pre-programmed Police Frequencies

(65 for Australia, 50 for New Zealand)

!3 Levels Preset Squelch

!Wide Band Scanner (400MHz - 512MHz)

!Band Search Function (5 Bands separately)

!LCD Display with Backlight

!Signal Strength Meter

!RF Power Indicator

!One touch Instant Channel recalling

!Duplex Capability (from CH01 - CH08)

!Group Scan and Priority Channel Watch

!Open Scan

!Busy Channel Lock-out

!38 Built-in CTCSS codes & 104 additional DCS codes

!Volume Control with Power On/Off Switch

!VOX (Voice Activated Function) optional VOX headset required

!9 Step VOX Mic sensitivity adjustment

!Memory backup if power fails

!Tone Squelch Function (5/6 Tone)

!Tone Calling Function (5/6 Tone)

!Tone Squelch Scan

!W125mm x H35mm x D156mm(including Display Unit) - allow 40mm+ for antenna fitting at rear of unit.

!DIN mountable (optional DIN mount kit required)

Preventative Maintenance:

The following system checks should be made every six to twelve months:

!Check the Standing Wave Ratio (SWR).

!Inspect the tightness of all electrical connections.

!Inspect the antenna coaxial cable for wear or breaks on the shielding.

!Inspect the tightness of all screws and other mounting hardware.

Troubleshooting:

Should the unit malfunction or perform poorly, follow these procedures:

If the transceiver is completely inoperative: Check the power cord and fuse.

If there is trouble with receiving: Check the VOLUME control setting. Be sure the SQUELCH is adjusted properly. Possibly the radio is over-squelched.

If there is trouble with transmitting: Check that the transmission line (coaxial cable) is securely connected to the ANTENNA connector. Check that the antenna is fully extended for proper operation. Check that all transmission line (coaxial cable) connections are secure and free of corrosion.

Blackening may occur on the Liquid Crystal Display if the uh015sx has been subjected to extreme high temperature (above 60°C) . This is not a fault. Normal LCD operation resumes when the temperature stabilizes back to standard operating