UNIDEN Model uh015sx UHF CB Radio
Operation
Operating the uh015sx in Duplex Mode
For this example we are adopting CH01 as the channel being used in your area for repeater use.
To Set Duplex ON/OFF
Press MENU once. The DUP setting will flash. Turn the rotary knob to adjust
the setting to 
or 
. Press & hold MENU /ENTER to set. A confirmation tone sounds.
The DUP icon appears.
MENU | SCAN | SRCH | MON |
ENTER | OS/GS | BAND/TSQ | SQL |
!Only channels 01 - 08 are available for Duplex.
!Check with your local Retailer for information on available repeaters.
!If a button is not pressed within 10 seconds the uh015sx will automatically exit MENU Mode.
Scanning
The uh015sx scanning feature allows you to search the SCAN MEMORY for active channels automatically.
The scan memory has two main groups; Open Scan (OS) and Group Scan (GS), OS Scan searches all the channels and frequencies in its memory continuously. GS Scan has the ability of monitoring a priority channel every 1.5 seconds while searching channels and frequencies in its memory.
Furthermore, while scanning you can select which channel groups to activate (CB or POLICE).
Press 
and Scanning starts. The SCN icon appears.
You may change the scan direction by turning the rotary channel selector.
Press 
again to exit scanning.
SCAN | SRCH | MON | HOLD | POL |
OS/GS | BAND/TSQ | SQL | DCS/CTCSS | MEM |
Open Scan (OS) Mode
Allows continuous scanning of channels stored in the Open Scan memory. If an active channel is found, scanning will stop on that channel.
This example shows CH17 active.
If the received signal ceases, the unit will wait 3 seconds for the signal to return, otherwise scanning resumes. During Scan you may...
! Press HOLD to hold scan. Press HOLD again to resume scan.
!If scan stops on a frequency and you wish to continue then turn rotary channel selector.
!The direction of scan can be changed using the rotary channel selector.
!To remove an active channel from scan memory press and hold POL /MEM and scan resumes.
!Press and hold
/OS/GS for 2 seconds to switch between GS and OS modes.
To deactivate scan, press 
momentarily.
!When Scan is deactivated the starting channel will be reinstated.
!If scan is deactivated while on hold the hold channel will be reinstated.
! OS Mode is indicated by the absence of the GS icon.
11