Stanley Black & Decker RW30 user manual Operation, Claw Version

Page 11

OPERATION

OVERVIEW

The RW30 is an electric arc welding controller to be used for gas-free sheathed wires. It is unbeatable on railroad worksites for performing maintenance and repairs on rails and track devices, railways, tramways, metros, shuttles, etc.

The RW30 after programming automatically executes the reloading of worn sections and accidental surface defects (on treads, rail butt joints, lateral wears, track devices), or the deposits of “safety stainless steel beads”.

The RW30 controls the motorized movement of the welding head in the X-axis (length) and Y-axis (width) for work over a surface area of 400 mm by 350 mm.

The RW30 frame is made of composites, aluminum and stainless steel. This principle of construction was retained to combine lightweight and excellent behavior under bad weather conditions.

The RW30 is sold as standard with : -1 RW30 Frame

-1 Rail Gripping Set

-1 Torch Support for the Pull Gun

-1 Charlie Control Box with its Connecting Cable

Frame

Torch Support

Rack

PREPARING THE RW30 FOR

OPERATION

CLAW VERSION

1. Position the claw on the rail.

2. Adjust the sliding jaw and tighten.

Adjustment

Tighten

3.Check the jaw angle and reference supports.

Jaw Angle

Reference

Supports

RW30 USER MANUAL - 11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Robotic Welder General Information Table of Contents Weisbeck, Andy Declaration of ConformityLocal Safety Regulations Safety SymbolsShock Hazard Safety PrecautionsRays from the ARC Welding HazardsGAS Cylinders Exhaust Fumes Make Sure Sparks from the Engine Exhaust do not Start a Fire Claw Version OperationClamp Version Setting the Stick OUT Charlie Control Unit Controls Automatic Track ModeAutomatic POINTS/FROG Mode Stop Manual Data Entry Language SettingSetting the Date and Time Printing DataHello Operator DialogueYES Valid Return Torch to Initial Point Spacing x.xx mm WELD.TIME xxmin Error MessagesUnvalid Point Return to PO1 « on » TRANSLAMATIC‘s green light does not work TroubleshootingFeeding RW30110 / RW30112 SpecificationsRW30 Cold Weather Update KIT RW30 Heater Installed 2009 or EarlierAccessories & Parts Spare Parts Template Guage Master Power Switch 2009 or EarlierMaster Power Switch 2010 or Later RW30110 / RW30112 Parts List & Illustration RW30120 Parts List & Illustration RW30110 / RW30112 / RW30120 Left Side Illustration RW30110 / RW30112 / RW30120 Right Side Illustration Right Side AssemblyRW30110 / RW30112 / RW30120 Motor Board RW30110 / RW30112 / RW30120 Support Platform RW30110 / RW30112 / RW30120 Support Assembly Clamp Assembly Torch Support Parts List & Illustration Torch Support Pull GUN Illustration Page Stanley Hydraulic Tools
Top Page Image Contents