Stanley Black & Decker RW30 user manual Setting the Stick OUT

Page 13

OPERATION

Adjusting the Clamp

CONNECTING THE WIRE FEED/

WELDING TIP TO THE RW30

1. Place the welding tip into the support.

2. Support swivel blocking lever.

Summary of steps shown above.

3. Support stick-out lever.

SETTING THE STICK OUT

The ideal setting is 30 mm. Use the template markers to check for proper distance.

30 mm

Ideal

Setting

RW30 USER MANUAL - 13

Image 13
Contents Robotic Welder General Information Table of Contents Weisbeck, Andy Declaration of ConformityLocal Safety Regulations Safety SymbolsShock Hazard Safety PrecautionsRays from the ARC Welding HazardsGAS Cylinders Exhaust Fumes Make Sure Sparks from the Engine Exhaust do not Start a Fire Claw Version OperationClamp Version Setting the Stick OUT Automatic POINTS/FROG Mode Automatic Track ModeCharlie Control Unit Controls Stop Setting the Date and Time Language SettingPrinting Data Manual Data EntryHello Operator DialogueYES Valid Return Torch to Initial Point Spacing x.xx mm WELD.TIME xxmin Error MessagesUnvalid Point Return to PO1 « on » TRANSLAMATIC‘s green light does not work TroubleshootingFeeding RW30110 / RW30112 SpecificationsRW30 Cold Weather Update KIT RW30 Heater Installed 2009 or EarlierAccessories & Parts Spare Parts Master Power Switch 2010 or Later Master Power Switch 2009 or EarlierTemplate Guage RW30110 / RW30112 Parts List & Illustration RW30120 Parts List & Illustration RW30110 / RW30112 / RW30120 Left Side Illustration RW30110 / RW30112 / RW30120 Right Side Illustration Right Side AssemblyRW30110 / RW30112 / RW30120 Motor Board RW30110 / RW30112 / RW30120 Support Platform RW30110 / RW30112 / RW30120 Support Assembly Clamp Assembly Torch Support Parts List & Illustration Torch Support Pull GUN Illustration Page Stanley Hydraulic Tools