Stanley Black & Decker RW30 user manual Return Torch to Initial Point

Page 19

OPERATION

If VALID key is pressed, torch will move to the starting point of the next bead.

RETURN TORCH TO

INITIAL POINT

Torch return to starting point and start welding of the next bead.

END LAYER N : 1

LAYER N : 2 - VAL

When resurfacing is over, the following message proposes to set a new resurfacing cycle:

If VALID key is pressed, you will have to set a new welding area. (As previously seen).

If RESET key is pressed:

NEUTRAL POINT ?

TRANSPORT - VALID

Allow to place the torch in « Parking » position.

If VALID key is pressed, torch will move to « Parking » posi- tion.

If RESET key is pressed, back to message:

HELLO

RETRACTING

POINT

Selection of Torch position after the welding of each bead (evacuation point).

The setting is done as:

PO1

TORCH:

Set point position O1.

PO2

TORCH:

Set point position O2.

PO3

TORCH:

Set point position O3.

TRIANGLE ?

NO - VALID

or

TRIANGLE ?

YES - VALID

NO ALIGNMENT

Note: This is also effective during all welding cycle.

To go to the next step press the VALID key.

To step back to the previous, press the RESET key.

SPEED : 30 cm/mn

Welding speed displayed cm/min (1 cm/min equals to 0.4 inch/min) (adjustable value in the parameter menu).

Triangle can be weld: if « NO », set point Position O4. If « YES », needed number of beads will be display.

PO4

TORCH:

Set point position O4.

NUMBER BEADS:

xx

Display the number of beads that will be made during the resurfacing (the surrounding is not included in this number). It is possible to modify this number if needed by pressing:

or

RW30 USER MANUAL - 19

Image 19
Contents Robotic Welder General Information Table of Contents Weisbeck, Andy Declaration of ConformityLocal Safety Regulations Safety SymbolsShock Hazard Safety PrecautionsRays from the ARC Welding HazardsGAS Cylinders Exhaust Fumes Make Sure Sparks from the Engine Exhaust do not Start a Fire Claw Version OperationClamp Version Setting the Stick OUT Automatic POINTS/FROG Mode Automatic Track ModeCharlie Control Unit Controls Stop Manual Data Entry Language SettingSetting the Date and Time Printing DataHello Operator DialogueYES Valid Return Torch to Initial Point Spacing x.xx mm WELD.TIME xxmin Error MessagesUnvalid Point Return to PO1 « on » TRANSLAMATIC‘s green light does not work TroubleshootingFeeding RW30110 / RW30112 SpecificationsRW30 Cold Weather Update KIT RW30 Heater Installed 2009 or EarlierAccessories & Parts Spare Parts Master Power Switch 2010 or Later Master Power Switch 2009 or EarlierTemplate Guage RW30110 / RW30112 Parts List & Illustration RW30120 Parts List & Illustration RW30110 / RW30112 / RW30120 Left Side Illustration RW30110 / RW30112 / RW30120 Right Side Illustration Right Side AssemblyRW30110 / RW30112 / RW30120 Motor Board RW30110 / RW30112 / RW30120 Support Platform RW30110 / RW30112 / RW30120 Support Assembly Clamp Assembly Torch Support Parts List & Illustration Torch Support Pull GUN Illustration Page Stanley Hydraulic Tools