OPERATION | ||
|
|
|
Starting/Shutdown Instructions
Starting the Engine
WARNING
• Do not touch electrically live parts of electrode with skin or wet clothing.
•Keep flammable material away.
Stopping the Engine
Remove all welding and auxiliary power loads and allow engine to run at low idle speed for a few minutes to cool the engine.
Stop the engine by placing the “Engine” switch in the “OFF” position.
A fuel shut off valve is not required on the WELD- MARK 225 because the fuel tank is mounted below the engine.
•Insulate yourself from work and
ground. Wear eye, ear, and body protection.
• Keep your head out of the fumes.
• Use ventilation or exhaust to remove fumes from breathing zone.
Be sure all
Remove all loads connected to the AC power recepta- cles. To start the engine, set the “Idler Control” switch
in the Automatic (
/
) position.
Use the choke control as follows:
Kohler Engine - Always pull the choke control out when starting the engine; cold, warm or hot. Place the “Engine” switch in the “ON” position.
Push the “START” button and crank the engine until it starts. Release the button as soon as the engine starts. Do not push the “START” button while the engine is running because this will cause damage to the ring gear and/or starter motor. After the engine has started, slowly return the choke control to the full “in” position (choke open).
After running at high engine speed for
Allow the engine to warm up by letting it run at low idle for a few minutes.
Break-in Period
It is normal for any engine to use a greater amount of oil until the
IMPORTANT: IN ORDER TO ACCOMPLISH THIS
The engine manufacturer’s recommendation for the running time until the first oil change is ( 5 ) HRS:
The oil filter is to be changed at the second oil change. Refer to the Engine Owner’s Manual for more information.
WELDMARK 225