DUTY CYCLE
Air compressors should be operated on not more than a 50% duty cycle. This means an air compressor that pumps air more than 50% of one hour is considered misuse, because
the air compressor is undersized for the required air demand. Maximum compressor pumping time per hour is 30 minutes.
ASSEMBLY
Contents of Carton
1 - | Air Compressor |
2 - | Wheels |
2 - | Shoulder Bolts, |
2 - | Hex Nuts, |
2 - | Rubber Bumpers |
2 - | Screws, |
Tools Required for Assembly
1 - 9/16” socket or open end wrench
1 - 1/2” socket or open end wrench
Unpacking
1.Remove all packaging leaving the air compressor on the pallet.
2.Remove and discard the (4) screws holding the air compressor to the pallet.
Screws
It may be necessary to brace
or support one side of the air compressor when removing the pallet because the air compressor will have a tendency to tip.
3.Carefully remove the air compressor from the pallet.
Assemble Wheels
It will be necessary to brace or support
one side of the outfit when installing the wheels because the compressor will have a tendency to tip.
1.Attach wheels with shoulder bolts and nuts as shown.
Rubber |
Feet |
Screw |
Nut |
Wheel |
Shoulder |
Bolt |
2.Tighten securely. NOTE: The outfit will sit level if the wheels are properly installed.
The wheels and handle do not
provide adequate clearance, stability or support for pulling the unit up and down stairs or steps. The unit must be lifted, or pushed up a ramp.
Assemble Rubber Feet
1.Attach rubber feet with the screws provided as shown in previous figure.
2.Tighten securely.
D24445 | 10- ENG |