Campbell Hausfeld FP2000, FP2012 operating instructions Maintenance

Operating Instructions FP2000, FP2012

Operation (Cont.)

2.Turning knob clockwise increases air pressure at outlet.

3.Turning counterclockwise will lower air pressure at outlet.

4.Fully counterclockwise will shut off flow of air completely.

CloseOpen

	Attach
Figure 8	Hose

REGULATED OUTLET GAUGE

2.Pull ring on safety valve and allow it to snap back to normal position.

Figure 10

! WARNING Safety valve must be replaced if it cannot be actuated or it leaks air after ring is released.

3.Turn power OFF and clean dust and dirt from motor, tank, air lines and pump cooling fins.

OIL CHANGE

1.Allow compressor to run and warm up oil.

2.Position a pan under pump end of unit.

3.Unplug unit. Remove drain plug, allow oil to collect in pan. Tilt unit to completely drain.

4.Replace drain plug, fill pump to full line on dipstick. Use Chevron synthetic 5W-30, Mobil 1 5W-30 or 0W-30 synthetic motor oil. Using other types of oil will cause starting problems.

AIR FILTER MAINTENANCE

1. This gauge shows at-a-glance, air	TANK DRAINAGE
pressure at outlet. Air pressure is	1. Daily with compressor shut off:
measured in pounds per square inch
	Drain moisture from tanks by
(PSI).
	opening drain cocks underneath
2. Be sure this gauge reads ZERO
	end of tanks.
before changing air tools or	2. There are two drain cocks, one for
disconnecting hose from outlet.
	each tank. Open both by turning
	counter-clockwise.

		3. Tilt unit to drain liquid. Dispose of
			condensation properly according to
			all laws and regulations.
Figure 9
TANK PRESSURE GAUGE
Gauge shows pressure in air receiver			Drain
indicating compressor is building pressure
properly.			Cock
			Open
! WARNING	Release all
	pressure and
disconnect power before making any
repair.
Maintenance			Drain
			Cock
1. Check compressor for any visible		Tilt to drain
problems, especially check oil level		Figure 11
to be sure it is at full line.
MAINTENANCE SCHEDULE
Operation		Daily	Monthly
Drain Tank		●
Check Oil Level		●
Check Safety Valve			●
Change Oil			●

Clean Air Filter	● (More often
	in dusty conditions)

1.Locate and remove the two Phillips head screws on the top of the air deflector over the cylinder head of the pump.

2.Lift off cover to expose the air filter.

3.Remove filter. Clean with air blast or soap and water. Replace filter if clogged or damaged.

4.Replace air deflector and screws. Do not operate without air deflector as the pump will overheat and become damaged.

Phillips Head Screws

Deflector

Filter

Figure 12

THERMAL OVERLOAD PROTECTOR

This compressor is

! WARNING equipped with a automatic reset thermal overload protector which will shut off motor if it becomes overheated. Motor can automatically restart at any time. Keep away from moving parts at all times.

www.chpower.com

5